Weber E/EP - 210/310 manual Main Burner Cleaning Procedure, Replacing Main Burners

MAINTENANCE 17

MAIN BURNER CLEANING PROCEDURE

Turn off the gas supply.

Remove the manifold (See “Replacing Main Burners”). Look inside each burner with a flashlight.

Clean the inside of the burners with a wire (a straightened-out coat hanger will work). Check and clean the air shutter opening at the ends of the burners. Check and clean the valve orifices at the base of the valves. Use a Steel bristle brush to clean outside of burners. This is to make sure all the burner ports are fully open.

CAUTION: Do not enlarge the burner ports when cleaning.

REPLACING MAIN BURNERS

1)Your Weber® gas barbecue must be OFF and cool.

2)Turn gas OFF at source.

3)To remove control panel:

(a)Take off the burner control knobs.

(b)Remove screw and washer from back of control panel with a Phillips screwdriver.

(c)Remove machine screw from lower left side of control panel with a Phillips screwdriver.

(d)Tilt the back edge of the control panel up. Carefully lift control panel up and away from frame.

(e)Disconnect the igniter wires from the ignition module.

(f)Replace control panel when Leak Check is completed.

a	b
c
d

e

WWW.WEBER.COM®