Gas Manifold Nut
10’ Natural Gas Hose
Cooking Grills
Heat Shields
Warming Rack
CONVERSION
INSTRUCTIONS
810-8500-S
CAUTION: Some parts may contain sharp edges. Wear protective gloves if necessary.
WARNING: Only use the specific orifice designated for your grill model. Always double check the millimeter size on the side of the orifice tip prior to installation. Use of any other orifice could lead to personal injury, property damage and void your grill warranty.
Note: Make sure all control knobs are in the off position, LP tank valve is closed and tank is disconnected from regulator and removed from grill.
Step 1
Using an adjustable wrench to hold the gas manifold connection secure, use a 3/4” wrench to loosen the hose connection nut. Replace existing LP hose/regulator assembly with natural gas 10’ hose assembly. Tighten the connection carefully using two wrenches.
Step 2
Remove cotter pin from side burner "foot". Carefully lift side burner up and away from valve nozzle. Set aside for later use.
Cotter Pin |
Step 3
Open hood and remove warming rack, cooking grills and heat shields. Set aside for later use.
22