Teledyne AX300-I manual √ Sensor

Portable Oxygen Analyzer		Service Manual
		adapter to prevent back filling.
		O2 flow rate should not
		exceed 5 l/min.
		C) Oxygen concentration at the
		sensor is significantly higher
		than 21%. Take the
		instrument to a well-
		ventilated area and check
		the reading again.
		E) Try calibrating with a known
		good sensor; if this fails, see
		symptom "Reading drifts
		over 2–3%..."
The sensor does not	Water is condensing	A) Remove the sensor from tee
react to changes in	on the sensing	adapter and unscrew the
oxygen concentration,	surface.	plastic flow diverter. Using
or the readings are	Electrical interference	absorbent tissue or cotton
unstable and drifting.		swab, gently wipe off sensing
	is disrupting the
		surface inside threaded
	electronics
		portion of sensor assembly.
		B) Relocate unit away from
		sources of electrical noise
		such as cauterizing equipment
		and two-way radios.
The display is flashing	The unit has detected	A) Check sensor cable
√ SENSOR	a fault in the signal	connections and make sure
	from the sensor.	they are completely
	Sensor has expired.	inserted into the mating
		connector and the capture
	The sensor has been	nut is firmly in place.
	exposed to a gas	B) Expose the sensor in 100%
	containing little or no
		O2 and check calibration.
	oxygen.
		C) The sensor output has
		fallen to a level where it is
		no longer usable. Replace
		sensor.
The oxygen reading	Like all O2 sensors,	A) During calibration, make
fluctuates or appears to	the R17MED detects	sure there is no restrictions
be incorrect.	the changes in the	on exhaust side of sensor. If
	partial pressure of	the reading changes with
	O2.	flow, the sensor is
		pressurized or there may be
		a leak in the system.
		B) If a high degree of accuracy
		is desired, or the

Teledyne Analytical Instruments 37