Invacare P9000 XDT manual General Guidelines

Page 13

SECTION 1—GENERAL GUIDELINES

DO NOT attempt to reach objects if you have to move forward in the seat.

DO NOT attempt to reach objects if you have to pick them up from the floor by reaching down between your knees.

DO NOT lean over the top of the back upholstery to reach objects from behind as this may cause the wheelchair to tip over.

DO NOT use an escalator to move a wheelchair between floors. Serious bodily injury may occur.

Before attempting to transfer in or out of the wheelchair, every precaution should be taken to reduce the gap distance. Turn both casters parallel to the object you are transferring onto. Also, be certain the power is off and the wheel locks are engaged to prevent the wheels from moving.

DO NOT engage or disengage the motor release levers until the power is in the off position.

Invacare strongly recommends proceeding down ramps or slopes at half speed or slower and to avoid hard braking or sudden stops.

DO NOT attempt to lift the wheelchair by lifting on any removable (detachable) parts. Lifting by means of any removable (detachable) parts of a wheelchair may result in injury to the user or damage to the wheelchair.

Anti-tippers MUST be used at all times. When outdoors on wet, soft ground or gravel surfaces, anti-tippers may not provide the same level of protection against tipover. Extra caution must be observed when traversing such surfaces.

Wheel locks are not brakes. DO NOT attempt to stop a moving wheelchair with the wheel locks.

DO NOT engage or disengage the clutches until the power is in the OFF position.

DO NOT operate on roads, streets or highways.

DO NOT climb, go up or down ramps or traverse slopes greater than 9°.

DO NOT attempt to move up or down an incline with a water, ice or oil film.

DO NOT attempt to drive over curbs or obstacles. Doing so may cause your wheelchair to turn over and cause bodily harm or damage to the chair.

DO NOT leave the power button in the on position when entering or exiting your wheelchair.

DO NOT stand on the frame of the wheelchair.

DO NOT use the footplates as a platform. When getting in or out of the wheelchair, make sure that the footplates are in the upward position or swing the footrests toward the outside of the chair.

DO NOT stand on the front riggings, otherwise damage may occur. When getting in or out of the wheelchair, make sure that the footplates on the front riggings are in the upward position or moved out of the way.

ALWAYS wear your seat positioning strap.

Part No. 1118386

13

P9000XDT

Image 13
Contents P9000 XDT P9000 XDT Table of Contents Arms CLUTCH/MOTOR Lock Complete and mail the form on the next Register Your ProductProduct Registration Form Fold here Cut Along Line Wheelchair TIE-DOWN Restraints and Seat Restraints Special NotesP9000 XDT Typical Product ParametersImportant Notice Label LocationsGeneral Guidelines Controller Settings/Repair or ServiceOperating Information General Guidelines Tire Pressure Electrical AccessoriesBatteries Charging Batteries Grounding InstructionsWeight Limitation Weight TrainingRain Test EMI Information EMI Information Stability and Balance SAFETY/HANDLING of WheelchairsCoping With Everyday Obstacles Tipping Curbs TippingLifting/Stairways Escalators Warning Transferring to and From Other SeatsReaching, Leaning and Bending Forward Percentage of Weight DistributionReaching, Leaning and Bending Forward Reaching and Bending BackwardSafety Inspection Checklists Safety INSPECTION/TROUBLESHOOTINGInspect/Adjust Initially Inspect/Adjust Monthly Inspect/Adjust WeeklyInspect/Adjust Periodically Troubleshooting Guide Troubleshooting MechanicalDON’T Checking Battery Charge LevelWheelchair Operation SPJJoystick Switches and IndicatorsInformation Gauge Display SPJJoystick Switches and IndicatorsWheelchair Operation Display Description Definition Using the Horn Turning the Power On/OffUsing the Joystick to Drive the Chair Operating the WheelchairMove the joystick in the following manner Installing Installing/Removing/Using the Footrest/LegrestFront Riggings Using Adjusting the Footrest HeightRemoving Replacing the Heel Loop Raising/Lowering the Legrest AssemblyRaising/Lowering the Legrest Assembly Arms Adjusting Armrest HeightReplacing Armrest Pad Swing-Back ArmsReplacing the Seat Upholstery Seat and BackReplacing the Back Upholstery Replacing the Back UpholsteryAdjusting the Back Height Adjusting the Back HeightReplacing Seat Positioning Strap Replacing Seat Positioning StrapPreparing the Joystick for Use JoystickRepositioning the Joystick Repositioning the JoystickCaster Adjusting ForksBatteries When to Charge BatteriesCharging Batteries Description and Use of Battery ChargersRecommended Battery Types Connecting the Battery ChargerReplacing the Batteries Cleaning Battery Terminals Removing/Installing the Battery BoxesRemoving/Installing Battery Boxes Installing/Removing Battery TrayTool QTY Comments Installing/Removing Batteries Into/From Battery BoxesPlace batteries into battery box bottom Connecting Battery CablesDirect Mount Method Connecting Battery CablesBatteries Connecting Battery Cables Direct Mount Method Connecting Battery Cables Battery Clamp Method Battery Clamp MethodBatteries Negative Positive + 10 Replacing Battery Box Retaining Strap Replacing Battery Box Retaining StrapEngaging/Disengaging the Clutches CLUTCH/MOTOR LockInstalling/Adjusting Installing/Adjusting/Using the Wheel LocksWheel Locks Installing/Adjusting/Using the Wheel Locks Adjusting Height Installing/Removing/Adjusting Anti-TippersANTI-TIPPERS Installing/Removing/Adjusting Anti-Tippers Transporting the P9000 XDT TransportingUnfolding/Folding the Wheelchair Transporting the P9000 XDT USA Limited Warranty