Invacare P9000 XDT manual Tire Pressure, Electrical Accessories, Batteries

Page 14

SECTION 1—GENERAL GUIDELINES

The seat positioning strap is a positioning belt only. It is not designed for use as a safety device withstanding high stress loads such as auto or aircraft safety belts. If signs of wear appear, belt must be replaced immediately.

Always verify that hand grips on the rear cane are secure prior to use when an assistant is used to propel or lift the chair. Check for any signs of looseness or deterioration and if found, contact a qualified technician. Do not attempt to move the wheelchair by using the hand grips if they are found to be unsecure or have deteriorated.

When cleaning rear cane or hand grip areas use only a clean towel lightly dampened with cool water. Verify that grips are dry prior to use. Use of soap or ammonia based cleaning solutions will result in the hand grips sliding off the cane assembly. Failure to observe this warning may result in injury to the user or bystanders.

DO NOT sit or transfer into the wheelchair unless it is fully open and the seat frame rails are fully seated into the side frame H-blocks.

Before performing any maintenance, adjustment or service verify that On/Off switch on the joystick is in the Off position.

Avoid storage or use near external flame or combustible products.

Tire Pressure

DO NOT use your wheelchair unless it has the proper tire pressure (P.S.I.).

DO NOT overinflate the tires. Failure to follow these suggestions can cause the tire to explode and cause bodily harm. The recommended tire pressure is listed on the side wall of the tire.

Electrical Accessories

EXTREME care should be exercised when using oxygen in close proximity to electric circuits and other combustible materials. Contact your oxygen supplier for instruction in the use of oxygen.

Batteries

The warranty and performance specifications contained in this manual are based on the use of deep cycle gel cell or sealed lead acid batteries. Invacare strongly recommends their use as the power source for this unit.

If wet cell batteries are used, follow all manufacturer guidelines and instructions for installation and maintenance. Regardless of battery type, proper battery footprint and use of battery terminal caps as defined in Batteries on page 47 must be followed.

Carefully read battery/battery charger information prior to installing, servicing or operating your wheelchair.

P9000XDT

14

Part No. 1118386

Image 14
Contents P9000 XDT P9000 XDT Table of Contents Arms CLUTCH/MOTOR Lock Register Your Product Complete and mail the form on the nextProduct Registration Form Fold here Cut Along Line Special Notes Wheelchair TIE-DOWN Restraints and Seat RestraintsTypical Product Parameters P9000 XDT Label Locations Important NoticeOperating Information Controller Settings/Repair or ServiceGeneral Guidelines General Guidelines Batteries Electrical AccessoriesTire Pressure Grounding Instructions Charging BatteriesRain Test Weight TrainingWeight Limitation EMI Information EMI Information Coping With Everyday Obstacles SAFETY/HANDLING of WheelchairsStability and Balance Tipping Tipping CurbsLifting/Stairways Transferring to and From Other Seats Escalators WarningPercentage of Weight Distribution Reaching, Leaning and Bending ForwardReaching and Bending Backward Reaching, Leaning and Bending ForwardInspect/Adjust Initially Safety INSPECTION/TROUBLESHOOTINGSafety Inspection Checklists Inspect/Adjust Periodically Inspect/Adjust WeeklyInspect/Adjust Monthly Troubleshooting Mechanical Troubleshooting GuideChecking Battery Charge Level DON’TSPJJoystick Switches and Indicators Wheelchair OperationSPJJoystick Switches and Indicators Information Gauge DisplayWheelchair Operation Display Description Definition Using the Joystick to Drive the Chair Turning the Power On/OffUsing the Horn Operating the WheelchairMove the joystick in the following manner Front Riggings Installing/Removing/Using the Footrest/LegrestInstalling Removing Adjusting the Footrest HeightUsing Raising/Lowering the Legrest Assembly Replacing the Heel LoopRaising/Lowering the Legrest Assembly Adjusting Armrest Height ArmsSwing-Back Arms Replacing Armrest PadSeat and Back Replacing the Seat UpholsteryReplacing the Back Upholstery Replacing the Back UpholsteryAdjusting the Back Height Adjusting the Back HeightReplacing Seat Positioning Strap Replacing Seat Positioning StrapJoystick Preparing the Joystick for UseRepositioning the Joystick Repositioning the JoystickAdjusting Forks CasterWhen to Charge Batteries BatteriesDescription and Use of Battery Chargers Charging BatteriesReplacing the Batteries Connecting the Battery ChargerRecommended Battery Types Removing/Installing the Battery Boxes Cleaning Battery TerminalsInstalling/Removing Battery Tray Removing/Installing Battery BoxesInstalling/Removing Batteries Into/From Battery Boxes Tool QTY CommentsConnecting Battery Cables Place batteries into battery box bottomConnecting Battery Cables Direct Mount MethodBatteries Connecting Battery Cables Direct Mount Method Battery Clamp Method Connecting Battery Cables Battery Clamp MethodBatteries Negative Positive + Replacing Battery Box Retaining Strap 10 Replacing Battery Box Retaining StrapCLUTCH/MOTOR Lock Engaging/Disengaging the ClutchesWheel Locks Installing/Adjusting/Using the Wheel LocksInstalling/Adjusting Installing/Adjusting/Using the Wheel Locks ANTI-TIPPERS Installing/Removing/Adjusting Anti-TippersAdjusting Height Installing/Removing/Adjusting Anti-Tippers Unfolding/Folding the Wheelchair TransportingTransporting the P9000 XDT Transporting the P9000 XDT Limited Warranty USA