Invacare P9000 XDT manual Repositioning the Joystick

SECTION 9—JOYSTICK

Repositioning the Joystick

NOTE: For this procedure, refer to FIGURE 9.2.

NOTE: Before starting this procedure, it may be necessary to snip the tie-wraps (not shown in FIGURE 9.2) securing the joystick control cord to the wheelchair. Before snipping the tie-wraps, note the way the cord is secured to the chair so that it can be re-secured in the same way at the end of the procedure.

1.Turn the adjustment lock lever to release the joystick mounting tube from the mounting bracket.

2.Remove the joystick from the wheelchair.

3.Remove the three (3) hex screws that secure both halves of the mounting bracket to the arm tube.

4.Reposition mounting bracket on opposite arm tube ensuring the threaded plate of the mounting bracket is on the inside of the arm tube.

5.Using the three (3) hex mounting screws and washers, secure both halves of the mounting bracket to the arm tube.

6.Slide the joystick mounting tube through the mounting bracket to the desired position.

7.Turn the adjustment lock lever to secure the joystick mounting tube into the mounting bracket.

8.If the tie-wraps securing the joystick control cord to the wheelchair were snipped at the beginning of this procedure, re-secure the cord to the wheelchair with new tie-wraps in such a way that the control cord will not be pinched or cut during operation of the wheelchair.

Mounting Bracket

(Threaded Plate)

Washers

Arm Tube

Hex Mounting

Screws

Adjustment	Mounting
Lock Lever	Bracket	Joystick

Joystick

Mounting

Tube

FIGURE 9.2 Repositioning the Joystick

Part No. 1118386 45 P9000™ XDT