SECTION
SECTION 10—CASTER
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that ON/OFF switch on the joystick is in the OFF position.
CAUTION
As with any vehicle, the wheels, casters and tires should be checked periodically for cracks and wear and should be replaced.
Adjusting Forks
NOTE: For this procedure, refer to FIGURE 10.1.
1.Remove the dust cover from the caster headtube.
2.To properly tighten caster journal system and guard against flutter, perform the following check:
A.Remove battery boxes and battery tray from wheelchair. Refer to Removing/Installing the Battery Boxes on page 50 and Installing/Removing Battery Tray on page 51.
B.Tip back the wheelchair to floor.
C.Pivot both forks and casters to top of their arc simultaneously.
D.Let casters drop to bottom of arc (wheels should swing once to
Dust Cover
Locknut
E.Adjust locknuts according to freedom of caster swing.
3.Test wheelchair for maneuverability.
4.Readjust locknuts if necessary, and repeat STEPS
5.Snap dust cover into the caster headtube.
Nylon
Washer
Caster Headtube
Fork
Caster
FIGURE 10.1 Adjusting Forks
P9000™ XDT | 46 | Part No. 1118386 |