Invacare P9000 XDT manual Adjusting the Footrest Height, Removing, Using

SECTION 6—FRONT RIGGINGS

Removing

1.Push the footrest release lever inward.

2.Rotate swingaway footrest assembly outward.

3.Lift the swingaway footrest assembly off of the hinge pins.

Using

1.To move the footrest out of the way without removing, push the footrest release lever inward, rotate footrest outward.

2.To lock the footrest, push the swingaway footrest assembly towards the inside of the wheelchair until it locks into place.

NOTE: The footplate will be on the inside of the wheelchair when locked in place.

Adjusting the Footrest Height

NOTE: For this procedure, refer to FIGURE 6.2.

NOTE: This procedure applies to the swingaway footrest and elevating legrest.

1.Remove the swingaway footrest assembly. Refer to Installing/Removing/Using the Footrest/Legrest on page 34.

NOTE: Lay the assembly on a flat surface to simplify this procedure.

2.Remove impact guards and/or calf strap, if installed.

3.Pull the cam lock lever up to the unlocked position.

4.Push in the release buttons and reposition the lower footrest assembly to the desired height.

5.Ensure that the release buttons fully protrude from holes on both sides of the upper footrest support.

6.Rotate cam lock lever down to locked position.

7.Replace impact guards and/or calf strap.

8.Repeat this procedure for the other footrest, if necessary.

9.Reinstall the swingaway footrest assembly. Refer to Installing/Removing/Using the Footrest/Legrest on page 34.

	Upper Footrest Support
	Release Button
Adjustment
Holes
Cam Lock Lever	Lower Footrest
	Assembly

FIGURE 6.2 Adjusting the Footrest Height

Part No. 1118386 35 P9000™ XDT