Invacare manual Transporting the P9000 XDT, Unfolding/Folding the Wheelchair

Page 66

TRANSPORTING

TRANSPORTING

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.

Transporting the P9000 XDT

WARNING

The weight of the wheelchair without the user and batteries is approximately 82 lbs. Use proper lifting techniques (lift with your legs) to avoid injury. Extreme caution is advised when it is necessary to move an unoccupied power wheelchair. Invacare recommends using two (2) assistants and making thorough preparations. Make sure to use ONLY secure, non-detachable parts for hand-hold supports.

NOTE: For this procedure, refer to FIGURE 15.1.

Unfolding/Folding the Wheelchair

WARNING

Keep hands and fingers clear of moving parts to avoid injury.

DO NOT place hand or fingers on the underside of the seat rail when opening or closing the wheelchair.

DO NOT sit or transfer into the wheelchair unless it is fully open and the seat rails are fully seated into the side frame H-blocks.

Unfolding

1.Push down on the seat rails until the seat rails are positioned in the seat guides.

2.Assemble the wheelchair by following the instructions in this manual.

Folding

1.Remove the anti-tippers. Refer to Installing/Removing/Adjusting Anti-Tippers on page 64.

1.Remove the batteries. Refer to Removing/Installing the Battery Boxes on page 50.

2.Remove the footrests/legrests from the wheelchair. Refer to Installing/Removing/Using the Footrest/Legrest on page 34.

3.Remove the battery tray from the wheelchair. Refer to Installing/Removing Battery Tray on page 51.

4.Lift up on the seat rails of the wheelchair.

P9000XDT

66

Part No. 1118386

Image 66
Contents P9000 XDT P9000 XDT Table of Contents Arms CLUTCH/MOTOR Lock Register Your Product Complete and mail the form on the nextProduct Registration Form Fold here Cut Along Line Special Notes Wheelchair TIE-DOWN Restraints and Seat RestraintsTypical Product Parameters P9000 XDTLabel Locations Important NoticeController Settings/Repair or Service General GuidelinesOperating Information General Guidelines Electrical Accessories Tire PressureBatteries Grounding Instructions Charging BatteriesWeight Training Weight LimitationRain Test EMI Information EMI Information SAFETY/HANDLING of Wheelchairs Stability and BalanceCoping With Everyday Obstacles Tipping Tipping CurbsLifting/Stairways Transferring to and From Other Seats Escalators WarningPercentage of Weight Distribution Reaching, Leaning and Bending ForwardReaching and Bending Backward Reaching, Leaning and Bending ForwardSafety INSPECTION/TROUBLESHOOTING Safety Inspection ChecklistsInspect/Adjust Initially Inspect/Adjust Weekly Inspect/Adjust MonthlyInspect/Adjust Periodically Troubleshooting Mechanical Troubleshooting GuideChecking Battery Charge Level DON’TSPJJoystick Switches and Indicators Wheelchair OperationSPJJoystick Switches and Indicators Information Gauge DisplayWheelchair Operation Display Description Definition Using the Joystick to Drive the Chair Turning the Power On/OffUsing the Horn Operating the WheelchairMove the joystick in the following manner Installing/Removing/Using the Footrest/Legrest InstallingFront Riggings Adjusting the Footrest Height UsingRemoving Raising/Lowering the Legrest Assembly Replacing the Heel LoopRaising/Lowering the Legrest Assembly Adjusting Armrest Height ArmsSwing-Back Arms Replacing Armrest PadSeat and Back Replacing the Seat UpholsteryReplacing the Back Upholstery Replacing the Back UpholsteryAdjusting the Back Height Adjusting the Back HeightReplacing Seat Positioning Strap Replacing Seat Positioning StrapJoystick Preparing the Joystick for UseRepositioning the Joystick Repositioning the JoystickAdjusting Forks CasterWhen to Charge Batteries BatteriesDescription and Use of Battery Chargers Charging BatteriesConnecting the Battery Charger Recommended Battery TypesReplacing the Batteries Removing/Installing the Battery Boxes Cleaning Battery TerminalsInstalling/Removing Battery Tray Removing/Installing Battery BoxesInstalling/Removing Batteries Into/From Battery Boxes Tool QTY CommentsConnecting Battery Cables Place batteries into battery box bottomConnecting Battery Cables Direct Mount MethodBatteries Connecting Battery Cables Direct Mount Method Battery Clamp Method Connecting Battery Cables Battery Clamp MethodBatteries Negative Positive + Replacing Battery Box Retaining Strap 10 Replacing Battery Box Retaining StrapCLUTCH/MOTOR Lock Engaging/Disengaging the ClutchesInstalling/Adjusting/Using the Wheel Locks Installing/AdjustingWheel Locks Installing/Adjusting/Using the Wheel Locks Installing/Removing/Adjusting Anti-Tippers Adjusting HeightANTI-TIPPERS Installing/Removing/Adjusting Anti-Tippers Transporting Transporting the P9000 XDTUnfolding/Folding the Wheelchair Transporting the P9000 XDT Limited Warranty USA