Invacare P9000 XDT manual Swing-Back Arms, Replacing Armrest Pad

SECTION 7—ARMS

Swing-Back Arms

WARNING

Make sure the armrest release lever is in the locked position before using the wheel- chair.

NOTE: For this procedure, refer to FIGURE 7.2.

1.Unlock the swing-back arms by rotating the armrest release lever towards the outside of the wheelchair.

2.Pull the front of the swing-back arm straight up/out of the arm socket and towards the rear of the wheelchair.

3.To use the swing-back arm, push the swing-back arm towards the front of the wheelchair and then downward into the arm socket.

NOTE: Armrest release lever MUST be in the unlocked position when placing armrest into the arm sockets.

4.Lock the swing-back arms by rotating the armrest release lever towards the inside of the wheelchair.

Swing Back Arm	Front
	Armrest Release Lever

Rear

Arm Socket

FIGURE 7.2 Swing-Back Arms

Replacing Armrest Pad

NOTE: For this procedure, refer to FIGURE 7.3

1.Remove the mounting screws that secure the armrest pad to the armrest assembly.

2.Replace armrest pad and securely tighten with the existing mounting screws.

Armrest Pad

Armrest Assembly

Mounting

Screws

FIGURE 7.3 Replacing Armrest Pad

Part No. 1118386 39 P9000™ XDT