Invacare P9000 XDT manual Grounding Instructions, Charging Batteries

Page 15

SECTION 1—GENERAL GUIDELINES

Charging Batteries

NEVER attempt to recharge the batteries by attaching cables directly to the battery terminals.

DO NOT attempt to recharge the batteries and operate the wheelchair at the same time.

DO NOT operate wheelchair with extension cord attached to the AC cable.

DO NOT attempt to recharge the batteries when the wheelchair has been exposed to ANY type of moisture.

DO NOT attempt to recharge the batteries when the wheelchair is outside.

DO NOT sit in the wheelchair while charging the batteries.

DO NOT attempt to recharge batteries using at the same time BOTH the on-board battery charger AND an independent battery charger plugged into the joystick charger port. Doing so will reduce the life of the batteries.

READ and carefully follow the manufacturer’s instructions for each charger (supplied or purchased). If charging instructions are not supplied, consult a qualified technician for proper procedures.

After charging batteries, ALWAYS make sure that the battery charger cord is unplugged. Failure to do this could result in damage to the cord or personal injury to the user or bystanders.

When using an extension cord, use only a three (3) wire extension cord having at least 16 AWG (American Wire Gauge) wire and the same or higher electrical rating as the device being connected.

Use of improper extension cord could result in risk of fire and electric shock.

Ensure the pins of the extension cord plug are the same number, size, and shape as those on the charger.

DO NOT under any circumstances cut or remove the round grounding plug from the charger AC cable plug or the extension cord plug.

Three (3) prong to two (2) prong adapters should not be used. Use of three (3) prong adapters can result in improper grounding and present a shock hazard to the user.

Grounding Instructions

DO NOT, under any circumstances, cut or remove the round grounding prong from any plug used with or for Invacare products. Some devices are equipped with three-prong (grounding) plugs for protection against possible shock hazards and fire. Where a two-prong wall receptacle is encountered, it is the personal responsibility and obligation of the customer to contact a qualified electrician and have the two-prong receptacle replaced with a properly grounded three-prong wall receptacle in accordance with the National Electrical Code. If you must use an extension cord, use ONLY a three-wire extension cord having the same or higher electrical rating as the device being connected. In addition, Invacare has placed RED/ORANGE warning tags on some equipment. DO NOT remove these tags.

Part No. 1118386

15

P9000XDT

Image 15
Contents P9000 XDT P9000 XDT Table of Contents Arms CLUTCH/MOTOR Lock Complete and mail the form on the next Register Your ProductProduct Registration Form Fold here Cut Along Line Wheelchair TIE-DOWN Restraints and Seat Restraints Special NotesP9000 XDT Typical Product ParametersImportant Notice Label LocationsController Settings/Repair or Service General GuidelinesOperating Information General Guidelines Electrical Accessories Tire PressureBatteries Charging Batteries Grounding InstructionsWeight Training Weight LimitationRain Test EMI Information EMI Information SAFETY/HANDLING of Wheelchairs Stability and BalanceCoping With Everyday Obstacles Tipping Curbs TippingLifting/Stairways Escalators Warning Transferring to and From Other SeatsReaching, Leaning and Bending Forward Percentage of Weight DistributionReaching, Leaning and Bending Forward Reaching and Bending BackwardSafety INSPECTION/TROUBLESHOOTING Safety Inspection ChecklistsInspect/Adjust Initially Inspect/Adjust Weekly Inspect/Adjust MonthlyInspect/Adjust Periodically Troubleshooting Guide Troubleshooting MechanicalDON’T Checking Battery Charge LevelWheelchair Operation SPJJoystick Switches and IndicatorsInformation Gauge Display SPJJoystick Switches and IndicatorsWheelchair Operation Display Description Definition Operating the Wheelchair Turning the Power On/OffUsing the Horn Using the Joystick to Drive the ChairMove the joystick in the following manner Installing/Removing/Using the Footrest/Legrest InstallingFront Riggings Adjusting the Footrest Height UsingRemoving Replacing the Heel Loop Raising/Lowering the Legrest AssemblyRaising/Lowering the Legrest Assembly Arms Adjusting Armrest HeightReplacing Armrest Pad Swing-Back ArmsReplacing the Seat Upholstery Seat and BackReplacing the Back Upholstery Replacing the Back UpholsteryAdjusting the Back Height Adjusting the Back HeightReplacing Seat Positioning Strap Replacing Seat Positioning StrapPreparing the Joystick for Use JoystickRepositioning the Joystick Repositioning the JoystickCaster Adjusting ForksBatteries When to Charge BatteriesCharging Batteries Description and Use of Battery ChargersConnecting the Battery Charger Recommended Battery TypesReplacing the Batteries Cleaning Battery Terminals Removing/Installing the Battery BoxesRemoving/Installing Battery Boxes Installing/Removing Battery TrayTool QTY Comments Installing/Removing Batteries Into/From Battery BoxesPlace batteries into battery box bottom Connecting Battery CablesDirect Mount Method Connecting Battery CablesBatteries Connecting Battery Cables Direct Mount Method Connecting Battery Cables Battery Clamp Method Battery Clamp MethodBatteries Negative Positive + 10 Replacing Battery Box Retaining Strap Replacing Battery Box Retaining StrapEngaging/Disengaging the Clutches CLUTCH/MOTOR LockInstalling/Adjusting/Using the Wheel Locks Installing/AdjustingWheel Locks Installing/Adjusting/Using the Wheel Locks Installing/Removing/Adjusting Anti-Tippers Adjusting HeightANTI-TIPPERS Installing/Removing/Adjusting Anti-Tippers Transporting Transporting the P9000 XDTUnfolding/Folding the Wheelchair Transporting the P9000 XDT USA Limited Warranty