Invacare P9000 XDT manual Charging Batteries, Description and Use of Battery Chargers

Page 48

SECTION 11—BATTERIES

Charging Batteries

WARNING

Never attempt to recharge the batteries by attaching cables directly to the battery terminals or clamps. Use the recharging plug located on the front of the joystick.

DO NOT attempt to recharge the batteries and operate the power wheelchair at the same time.

During use and charging, unsealed batteries will vent hydrogen gas which is explosive in the right concentration with air. Follow the manufacturer's charging instructions.

CAUTION

Always charge new batteries before initial use or battery life will be reduced.

NOTE: As a general rule, batteries should be recharged daily to assure the longest possible life and minimize the required charging time. Plan to recharge the batteries when it is anticipated the wheelchair will not be used for a long period of time.

The range per battery charge using recommended batteries should be approximately 5 to 9 hours of typical operation. Extensive use on inclines may substantially reduce per charge mileage.

Description and Use of Battery Chargers

The charger automatically reduces the charge from an initially high rate to a zero reading at a fully charged condition. If left unattended, the charger should automatically shut-off when full charge is obtained.

Some basic concepts which will help you understand this automatic process are:

The amount of electrical current drawn within a given time to charge a battery is called “charge rate”. If, due to usage, the charge stored in the battery is low, the charge rate is high, as indicated by the green light on the charger. Initially, the green light will stay illuminated for a short period of time followed by a longer period of off time. As a charge builds up, the charge rate is reduced, and the green light will stay illuminated for a longer period of time followed by a shorter off time.

NOTE: If performing the charging procedures independently, READ and CAREFULLY follow the individual instructions for each charger (supplied or purchased).

NOTE: If charging instructions are not supplied, consult a qualified service technician for proper procedures. Required items:

TOOLS

QUANTITY

COMMENTS

 

 

 

Battery charger

1

Supplied

*Extension cord

1

Not Supplied

 

 

 

*NOTE: 3-prong plug, 15 ampere current rating; industrial type

P9000XDT

48

Part No. 1118386

Image 48
Contents P9000 XDT P9000 XDT Table of Contents Arms CLUTCH/MOTOR Lock Register Your Product Complete and mail the form on the nextProduct Registration Form Fold here Cut Along Line Special Notes Wheelchair TIE-DOWN Restraints and Seat RestraintsTypical Product Parameters P9000 XDTLabel Locations Important NoticeController Settings/Repair or Service General GuidelinesOperating Information General Guidelines Electrical Accessories Tire PressureBatteries Grounding Instructions Charging BatteriesWeight Training Weight LimitationRain Test EMI Information EMI Information SAFETY/HANDLING of Wheelchairs Stability and BalanceCoping With Everyday Obstacles Tipping Tipping CurbsLifting/Stairways Transferring to and From Other Seats Escalators WarningPercentage of Weight Distribution Reaching, Leaning and Bending ForwardReaching and Bending Backward Reaching, Leaning and Bending ForwardSafety INSPECTION/TROUBLESHOOTING Safety Inspection ChecklistsInspect/Adjust Initially Inspect/Adjust Weekly Inspect/Adjust MonthlyInspect/Adjust Periodically Troubleshooting Mechanical Troubleshooting GuideChecking Battery Charge Level DON’TSPJJoystick Switches and Indicators Wheelchair OperationSPJJoystick Switches and Indicators Information Gauge DisplayWheelchair Operation Display Description Definition Turning the Power On/Off Using the HornUsing the Joystick to Drive the Chair Operating the WheelchairMove the joystick in the following manner Installing/Removing/Using the Footrest/Legrest InstallingFront Riggings Adjusting the Footrest Height UsingRemoving Raising/Lowering the Legrest Assembly Replacing the Heel LoopRaising/Lowering the Legrest Assembly Adjusting Armrest Height ArmsSwing-Back Arms Replacing Armrest PadSeat and Back Replacing the Seat UpholsteryReplacing the Back Upholstery Replacing the Back UpholsteryAdjusting the Back Height Adjusting the Back HeightReplacing Seat Positioning Strap Replacing Seat Positioning StrapJoystick Preparing the Joystick for UseRepositioning the Joystick Repositioning the JoystickAdjusting Forks CasterWhen to Charge Batteries BatteriesDescription and Use of Battery Chargers Charging BatteriesConnecting the Battery Charger Recommended Battery TypesReplacing the Batteries Removing/Installing the Battery Boxes Cleaning Battery TerminalsInstalling/Removing Battery Tray Removing/Installing Battery BoxesInstalling/Removing Batteries Into/From Battery Boxes Tool QTY CommentsConnecting Battery Cables Place batteries into battery box bottomConnecting Battery Cables Direct Mount MethodBatteries Connecting Battery Cables Direct Mount Method Battery Clamp Method Connecting Battery Cables Battery Clamp MethodBatteries Negative Positive + Replacing Battery Box Retaining Strap 10 Replacing Battery Box Retaining StrapCLUTCH/MOTOR Lock Engaging/Disengaging the ClutchesInstalling/Adjusting/Using the Wheel Locks Installing/AdjustingWheel Locks Installing/Adjusting/Using the Wheel Locks Installing/Removing/Adjusting Anti-Tippers Adjusting HeightANTI-TIPPERS Installing/Removing/Adjusting Anti-Tippers Transporting Transporting the P9000 XDTUnfolding/Folding the Wheelchair Transporting the P9000 XDT Limited Warranty USA