Invacare P9000 XDT manual Batteries

SECTION 11—BATTERIES

CAUTION

When connecting the battery cables to the battery(ies), the battery cable(s) MUST be connected to the battery terminal(s)/post(s) as shown in Detail “A” or Detail “B” of FIGURE 11.7 (depending on battery type). Otherwise, damage to the battery cable may result when installing battery terminal caps.

2.Connect battery cable(s) to battery(ies) terminal(s)/post(s) as shown in Detail “A” or Detail “B” of FIGURE 11.7, depending on battery type:

A.NEGATIVE (-) BLACK battery cable to NEGATIVE (-) battery terminal/post.

B.POSITIVE (+) RED battery cable to POSITIVE (+) battery terminal/post.

3.Secure the battery cable(s)/ring terminal(s) to the battery terminal(s)/post(s), BLACK to NEGATIVE (-) and RED to POSITIVE (+), with the provided 1/4-20 x 7/8-inch hex flange screw and hex flange locknut as shown in Detail “A” or Detail “B” of FIGURE 11.7, depending on battery type. Securely tighten.

4.Verify all battery cable(s)/ring terminal(s) are correctly installed and securely tightened.

5.Slide terminal cap(s) down battery cable(s) and onto battery clamps.

6.Using the 11½-inch long tie-wrap, secure each terminal cap in place (Detail “A” or Detail “B” of FIGURE 11.7).

NOTE: It will be necessary to trim excess tie-wrap in order to install the battery box top(s).

7. Install the battery box top(s).

Part No. 1118386 55 P9000™ XDT