Invacare P9000 XDT manual Replacing the Back Upholstery

SECTION 8—SEAT AND BACK

Replacing the Back Upholstery

NOTE: For the following procedure, refer to FIGURE 8.2.

1.Flip swing back arms up and out of the way. Refer to Swing-Back Arms on page 39.

2.Remove the six (6) mounting screws and washers that secure the EXISTING back upholstery to the back canes.

3.Cut the tie wraps that secure the existing back upholstery to the wheelchair frame.

4.Securely tighten the NEW back upholstery to the back canes with the six (6) mounting screws and washers starting with the top hole of the back cane.

5.Install two (2) NEW tie wraps through the bottom holes of the upholstery to the bottom of the back upholstery to the back canes.

6.Flip swing-back arms down for use. Refer to Swing-Back Arms on page 39.

	Washers	Back Upholstery
Mounting Screws		Back Cane

Tie Wraps	Washers
	Mounting Screws

FIGURE 8.2 Replacing the Back Upholstery

Part No. 1118386 41 P9000™ XDT