Invacare P9000 XDT manual Adjusting the Back Height

SECTION 8—SEAT AND BACK

Adjusting the Back Height

NOTE: For this procedure, refer to FIGURE 8.3.

NOTE: Back canes must be adjusted to the same height.

1.Remove the two (2) mounting screws and locknuts that secure the two (2) back canes to the wheelchair frame.

2.Reposition the back canes to the desired height adjustment position.

3.Reinstall the mounting screws and locknuts that secure the back canes to the wheelchair frame and securely tighten.

Back Cane

Wheelchair Frame

Mounting Screw Locknut

Back Height (in inches)

*HOLE#	1	2	3
HEIGHT	17	18	19

*NOTE: Holes numbered from bottom to top for reference only. (There are no numbers on the back canes or wheelchair frame.)

FIGURE 8.3 Adjusting the Back Height

P9000™ XDT 42 Part No. 1118386