Panasonic MCUL815 operating instructions Replacing Belt

Page 48

Replacing Belt

Side Latch

Loquet latéral

Pestillo laterale

Rear Latch

Loquet arrière

Pestillo trasero

Nozzle Cover	Side Latch
Couvercle de la	Loquet latéral
tête d'aspiration	Pestillo laterale
Cubierta de la boquilla

	Belt
	Courroie
Agitator	Correa
Agitateur
Agitador

Motor Shaft

Arbre du moteur

Eje del motor

			Belt Guide
			Glissière de
			la courroie
		End Cap	Guía para la
	Belt Groove	End Cap	correa
	Belt Groove	Bouchon	correa
	Rainure de	Bouchon
	Rainure de	Tapa del
	la courroie	Tapa del
	la courroie	extremo
	Polea para	extremo
	Polea para
	correa

➢Replace belt whenever a burning rubber smell caused by excessive slippage occurs.

➢Turn off and unplug the vacuum cleaner.

➢Push in rear nozzle latch.

➢Press side latches towards back of nozzle and rotate cover from nozzle.

➢Remove agitator by carefully lifting out.

➢Remove worn or broken belt.

➢Clean agitator and the end caps.

CAUTION

Motor shaft may be hot.

➢Loop new belt (part number MC-V380B) around motor shaft and agitator belt groove. Make sure belt is routed in the belt guide as shown. See illustration for correct belt routing.

➢Reinstall agitator back into nozzle by placing end caps into grooves.

➢After reinstalling the agitator, turn it by hand to make sure that belt is not twisted or pinched and that all rotating parts turn freely.

➢Reinstall nozzle cover by aligning front edge of the cover with the nozzle and rotating. Ensure rear latch and side latches are locked into slots by pressing firmly.

- 48 -

Image 48

Contents Operating Instructions Table of Contents Tabla de contenido Consumer Information Avertissement Advertencia Cuidado Important Safety Instructions Importantes mesures de sécurité Advertencia Nomenclature Identificación de piezasTableau des caractéristiques / Diagrama de características Assembly Attaching HandleMontage du manche Colocación del mangoAttaching Hose Attachment StorageConectando la manguera To Operate Vacuum Cleaner Para Utilizar LA Aspiradora Precaución Power Cord Advertencia On/Off Switch Control On-Off Adjusting the Handle Posiiciones de la aspiradora Using Tools Carpet/Bare Floor SelectorSélecteur tapis/plancher Selector alfombra-pisoCollar Page Tools Accessoires AccesoriosEdge Cleaning Thermal ProtectorProtecteur thermique Protector termalDirt Sensor Détecteur de poussière Sensor de basuraRoutine Care of Vacuum Cleaner Cleaning Exterior and ToolsNettoyage du boîtier et des Accessoires Limpieza del exterior y de las HerramientasEmptying Dust Bin Entretien du godet à poussière Vaciar el contendaor de polvoTo Replace Dust BIN Remise en place du godet à poussière Cleaning Pre-Filter Nettoyage du préfiltre Limpieza del Pre-Filtro Cleaning Primary Filter Filter ScreenNettoyage du filtre primaire Limpiar el filtro primario Tamis DU FiltreTo Replace Filters Para Remplazar LOS Filtros Removing Clogs Dégagement des obstructions Quitando los residuos de basura en Los conductosReplacing Belt Remplacement de la courroie Cambio de la correaReplacing Hepa Exhaust Filter Remplacement du filtre ’évacuation Hepa Cambo del filtro de escape HepaCleaning Agitator Nettoyage de l’agitateur Limpieza del agitadorCleaning Dirt Sensor Optics Nettoyage des cellules optiques du Détecteur de poussière Before Requesting Service Avertissement Antes de pedir servicio Page Page Page Warranty Customer Services Directory United States and Puerto Rico Exchange Program 5770, Ambler Drive, Mississauga Ontario L4W 2T3Garantie Garantía Compra de Accesorios Estados Unidos y Puerto Rico Cuando necesita servicio