English
Our products are designed to meet the highest standards of quality, functionality and design. We hope you enjoy your new Braun appliance.
Warning
•Keep the appliance dry.
•Do not wind the cord around the appliance.
•For safety reasons, periodically check the cord for damage and replace it if necessary.
Description
1a | Small distance comb (trimming | 3 | Speed selector |
| beard and short hair) | 4 | On/off switch |
1b | Large distance comb (cutting hair) |
| with beard length selector |
2 | Cutter system | 5 | Memory switch |
| a beard trimming/hair trimming |
| (for 6 beard length settings) |
| b release buttons | 6 | Pilot light |
Technical specifications
Power supply: 100 – 240 V 2 / 50 or 60 Hz (automatic adaptation)
Wattage: 5
Charging your beard trimmer for cordless operation
•Connect the trimmer to the mains with the on/off switch on position «0» and charge it for at least 8 hours. The pilot light indicates that the trimmer is connected to the mains.
•Once the trimmer is completely charged, use it without the cord until discharged.
•Then recharge to full capacity again (subsequent charges will take about 8 hours).
•A full charge will give up to 30 minutes of cordless trimming depending on your beard. However, the maximum capacity will only be reached after several charging/discharging cycles.
•Best environmental temperature range for charging is 15 °C to 35 °C.
•If the rechargeable battery is discharged, you may also operate the trimmer via the mains cord. (If the trimmer does not run immediately, charge it for approx. 1 minute.)
7