Invacare Paul Schulte Signature BB, X-Terminator Titanium Transferring To and From Other Seats

Page 23

SECTION 2—SAFE HANDLING

3.The second assistant, with a firm hold on a non‐detachable part of the framework, lifts the wheelchair up and over the stair and steadies it as the first assistant places one foot on the next stair and repeats procedure.

4.The wheelchair should not be lowered until the last stair has been negotiated and it has been rolled away from the stairway.

5.If equipped, turn the anti‐tippers down. Refer to Footrest/ Anti‐Tipper on page 62 in this manual.

WARNING

DO NOT use an escalator to move a wheelchair between floors. Serious bodily injury may occur.

Transferring To and From Other Seats

WARNING

BEFORE attempting to transfer in or out of the wheelchair, every precaution should be taken to reduce the gap distance. Turn both casters parallel to the object you are transferring onto. Also be certain the wheel locks are engaged to help prevent the wheels from moving.

When transferring, position yourself as far back as possible in the seat. This will pre- vent damaged upholstery and the possibility of the wheelchair tipping forward.

NOTE: This activity may be performed independently provided you have adequate mobility and upper body strength.

Position the wheelchair as close as possible along side the seat to which you are transferring, with the front casters parallel to it. Remove the armrest, if installed. Engage wheel locks. Shift body weight into seat with transfer.

During independent transfer, little or no seat platform will be beneath you. Use a transfer board if at all possible.

Part No 1114851

23

Everyday and Sport Series Wheelchairs

Image 23
Contents Everyday and Sport Series Wheelchairs Everyday and Sport Series Wheelchairs Table of Contents Wheels Suspension Complete and mail the form on the next Register Your ProductProduct Registration Form Fold Here Cut Along Line Wheelchair TIE-DOWN Restraints and Seat Positioning Straps Special NotesTerminator Typical Product ParametersTypical Product Parameters Terminator Titanium Titanium Paul Schulte Signature BB Transformer ALL-SPORT Operating Information General GuidelinesStability Warning General Guidelines Tire Pressure and Information Weight TrainingWeight Limitation Stability and Balance Safe HandlingCoping with Everyday Obstacles Percentage of Weight DistributionReaching, Leaning Backwards Reaching, Leaning and Bending ForwardTipping Curbs TippingStairways Transferring To and From Other Seats Inspect Initially Safety InspectionSafety Inspection Checklist Inspect/Adjust Monthly Inspect/Adjust WeeklyInspect/Adjust Periodically TroubleshootingSuggested Maintenance Procedures MaintenanceMaintenance Safety Precautions Safety Inspection Unfolding/Folding the Back Back Angle AdjustmentBack Back Angle Adjustment Removing Foldover Back Upholstery Removing/Installing Foldover Back UpholsteryInstalling Foldover Back Upholstery Back Upholstery Cover Adjustable Tension Back UpholsteryAdjustable Tension Straps Replacing Adjustable Tension Back UpholsteryBack Height Adjustment Adjustable Backs Only Back Original Back Height in Inches Wheels Removing/Installing Rear WheelsReplacing Quad-Release Axles Adjusting Quick-Release AxlesRemoving Play from Rear Wheels Adjusting Quad-Release HandlesAnd/or Out Repairing/Replacing Rear Wheel, Tire/Tube Handrim ReplacementOpening/Closing Camber Clamps Opening/Closing Camber Clamps A4 Camber System Adjusting Rear Wheel CamberCamber Tube Determining Toe In/Toe Out Adjusting Toe In/Toe Out Camber Tube Adjusting Toe In/Toe OutCourse Adjustment Fine Adjustment 11 Adjusting Toe In/Toe Out A4 Camber System Fine Adjustment Adjusting Wheelbase Length Adjusting Center of Gravity12 Adjusting Wheelbase Length Adjusting Center of Gravity 13 Adjusting Wheelbase Width Camber Tube Adjusting Wheelbase WidthReplacing Axle Tube 14 Adjusting Wheelbase Width A4 Camber SystemWheels Adjusting the Axle Tube 16 Adjusting the Axle Tube Camber Tube 17 Adjusting the Axle Tube A4 Camber System Repeat Steps 1‐3 for the opposite caster if necessary Replacing/Adjusting CastersParallel to the floor Adjusting Front Caster HeightWheel Lock Adjustment/Replacement 20 Wheel Lock Adjustment/Replacement Seat Replacing Adjustable Tension Seat UpholsteryReplacing Screw-On Seat Upholstery Replacing Adjustable Tension Seat UpholsteryAdjusting Rear Seat Height Adjusting Transformer Seat HeightAdjusting Front Seat Height Adjusting Transformer Seat Height Replacing the Footrest Adjusting the FootrestFootrest ANTI-TIPPER Adjusting Installing/Adjusting Optional Clamp on Raised FootrestReplacing/Adjusting Optional A4 Footrest InstallingAdjusting Footplate Depth Installing the X-Terminator FootrestAdjusting Footplate Angle Terminator Height Adjusting the X-terminator and Transformer FootrestsDepth AngleAdjusting/Replacing Anti-tipper Replacing Anti-tipper Adjusting Anti-tipperRemoving Installing/Removing/Adjusting Swivel Anti-TipInstalling/Depth Adjustment Paul Schulte Signature BB and T-5 Tennis Elite Models only Adjusting HeightElastomers and Suspension Replacing Rear Elastomers SuspensionReplacing Rear Elastomers Replacing Front ElastomersReplacing Front Elastomers WING/BUMPER Installing/Removing the Wing/BumperWING/BUMPER Limited Warranty USA