Invacare Paul Schulte Signature BB, 1114851 Replacing Front Elastomers, Replacing Rear Elastomers

SECTION 8—SUSPENSION

Outside of	Suspension Base
Wheelchair Frame

Outer Allen

Screw Recess

Elstaomer

Pivot Pin

Inner Allen

Screw

Axle Bracket

Mounting	Recess
Holes	Inside of Wheelchair Frame

FIGURE 8.1 Replacing Rear Elastomers

Replacing Front Elastomers

CAUTION

DO NOT use excessive force when removing/installing the threaded sleeve from/onto the fork. Damage to the threaded sleeve may occur.

NOTE: For this procedure, refer to FIGURE 8.2.

1.Using two allen wrenches, turn in opposite directions and remove one mounting screw from fork.

NOTE: One mounting screw will not turn.

2.Remove the threaded sleeve and mounting screw assembly from the fork. DO NOT use excessive force.

3.Remove the existing elastomer from the fork.

4.Install NEW elastomer determined in STEP 1 into fork.

NOTE: Make sure the elastomer sits in the two recessed areas on the fork.

5.Align the mounting holes in the upper and lower portion of the fork.

6.Reinstall threaded sleeve and mounting screw assembly. DO NOT use excessive force.

Part No 1114851 71 Everyday and Sport Series Wheelchairs