Invacare X-Terminator Titanium, X-Terminator QR, X-Terminator BB Wheel Lock Adjustment/Replacement

SECTION 5—WHEELS

Wheel Lock Adjustment/Replacement

NOTE: For this procedure, refer to FIGURE 5.20.

NOTE: Invacare recommends low mount wheels locks when engaging in any contact sport.

NOTE: Before adjusting or replacing the High/Low mount wheel locks, ensure that the tires are inflated to the recommended psi on the sidewall of the tire.

1.Loosen the locknuts and hex/allen screws that secure the High/Low mount wheel locks to side frame.

2.Perform one of the following:

•Replacing the High/Low Mount Wheel Lock:

i.Remove the locknuts and hex/allen screws and remove existing wheel lock from the wheelchair.

ii.Install the new wheel lock and adjust.

•Adjusting the High/Low Mount Wheel Lock:

i.Measure the distance between the wheel lock shoe and the rear wheel.

ii.Slide the wheel lock along the wheelchair until the measurement is between 5/32 and 5/16‐inches.

iii.Tighten the wheel lock to the wheelchair frame.

iv.Repeat this procedure for the opposite wheel lock.

v.Engage the wheel locks and push against the wheelchair to determine if the wheel locks engage the rear wheels enough to hold the occupied wheelchair.

vi.Repeat STEPS i‐v until the wheel locks engage the rear wheels enough to hold the occupied wheelchair.

Everyday and Sport Series Wheelchairs 56 Part No 1114851