SECTION
Adjusting Rear Wheel Camber
NOTE: For this procedure, refer to FIGURE 5.7.
Camber Tube 2000
The axle tube must be replaced to change the camber. Refer to Replacing Axle Tube on page 49.
A4 Camber System
NOTE: Perform this procedure to one side of the wheelchair at a time for ease of adjustment.
1.Open the camber clamp. Refer to Opening/Closing Camber Clamps on page 39.
2.Pull one rear wheel with camber insert out of axle tube.
3.Remove the rear wheel from the camber insert.
4.Rotate the camber insert 180°.
5.Reinstall the rear wheel into the camber insert.
Rear View of Wheelchair |
| |
Camber Insert - | Axle | |
Tube | ||
Rotate 180° | ||
|
Indexing Ring | Camber | |
Indexing Marks | ||
Clamp | ||
|
FIGURE 5.7 Adjusting Rear Wheel Camber
- A4 Camber System
WARNING
NEVER position the camber inserts in the axle tube with more than
6.Position the camber insert to the desired position. Make sure there is no more than 3 inches (12 indexing marks) of the camber inserts outside of the axle tube.
7.Slide the indexing ring on the camber insert until it is flush with the camber clamp.
NOTE: Before using the wheelchair, make sure both camber inserts are set to the same indexing mark. This will make sure the distance between the rear wheel and the wheelchair is the same on both sides.
WARNING
QUICK RELEASE LEVERS - Make sure the quick release levers are pointing towards the rear of the wheelchair and are in the closed position before using the wheelchair, otherwise personal injury or damage to the wheelchair may occur.
Part No 1114851 | 41 | Everyday and Sport Series Wheelchairs |