SECTION 5—WHEELS
10.Reposition the camber inserts to the highest degree of camber. Refer to Adjusting Rear Wheel Camber on page 41.
11.Repeat STEP 3.
12.Close the left camber clamp. Refer to Opening/Closing Camber Clamps on page 39.
13.Rotate the right toe adjustment ring until the tab stops against the upper metal tab on the camber clamp.
14.Securely tighten set screw on right toe adjustment ring.
15.Repeat STEP 7.
16.Perform one of the following:
•Toe In/Toe Out Measurement is Within ±1/8‐inch ‐
i.Proceed to STEP 17.
•Toe In/Toe Out Measurement is Not Within ±1/8‐inch ‐
i.Repeat STEP 1.
ii.Loosen the set screw on the right toe adjustment ring.
iii.Repeat STEP 3.
iv.Repeat STEPS 12‐16 until toe in/toe out measurement is within ±1/8 inch.
17.If desired, reposition camber inserts to the desired degree of camber. Refer to Adjusting Rear Wheel Camber on page 41.
| Place “L” Square Here | ||
Flat Edge of | 90° Angle | Ground/Floor | |
Camber Tube | |||
|
|
| Lower Degree of Camber | |
Left Tab | Left Toe | |
Adjustment | ||
Stopped | ||
Ring | ||
Against | ||
| ||
Lower Edge |
| |
of Camber |
| |
Clamp | Camber | |
| Clamp |
Axle Tube - Will
Rotate Up only
Higher Degree of Camber
Axle Tube - Will Rotate Down only
Right Toe Adjustment
Ring
Right Tab | Camber |
Stopped | Clamp |
Against |
|
Upper Edge |
|
of Camber |
|
Clamp |
|
FIGURE 5.17 Adjusting the Axle Tube - A4 Camber System
Part No 1114851 | 53 | Everyday and Sport Series Wheelchairs |