Invacare Terminator BB, X-Terminator Titanium, X-Terminator QR, T-5 Tennis Elite Fine Adjustment

SECTION 5—WHEELS

Stop - Not touching	Stop - In position for one
	camber, touching camber clamp
camber clamp
	Adjustment Ring
Adjustment Ring
Camber Clamp	Camber Clamp

Stop - In position for one

camber, touching camber clamp

Adjustment Ring

Adjustment Ring	Stop - Not touching
	camber clamp

FIGURE 5.10 Adjusting Toe In/Toe Out - A4 Camber System - Course Adjustment

NOTE: DO NOT tighten the phillips screw on the other adjustment ring at this time.

NOTE: Repeat STEPS 1‐7 of this procedure for the other adjustment ring after repositioning the camber insert. Refer to Adjusting Rear Wheel Camber on page 41.

NOTE: When positioning the other adjustment ring, rotate the ring until the stop is at the bottom of the slot in the camber clamp. The right and left stops MUST be positioned opposite to each other or Fine Adjustment on page 45 will not work correctly.

NOTE: When the left adjustment ring is adjusted to a camber, the right adjustment ring will not touch the camber clamp and when the right adjustment ring is adjusted to the other camber the left adjustment ring will not touch the camber clamp.

Fine Adjustment

NOTE: For this procedure, refer to FIGURE 5.11.

NOTE: This adjustment is required anytime the camber insert is repositioned.

1.Open the camber clamp. Refer to Opening/Closing Camber Clamps on page 39.

2.Slowly rotate the axle tube until the stop on the opposite adjustment ring is positioned at the opposite end of the camber clamp.

WARNING

QUICK RELEASE LEVERS - Make sure the quick release levers are pointing towards the rear of the wheelchair and are in the closed position before using the wheelchair, otherwise personal injury or damage to the wheelchair may occur.

Part No 1114851 45 Everyday and Sport Series Wheelchairs