Invacare X-Terminator BB, X-Terminator Titanium Installing/Removing/Adjusting Swivel Anti-Tip

Page 68

SECTION 7—FOOTREST/ ANTI-TIPPER

DETAIL “A” - ANTI-TIPPER

ADJUSTMENT HOLES

Top Adjustment Hole

Anti-Tipper Bar

Release Buttons

Anti-Tipper

Hole

Camber Clamp

 

 

Anti-Tipper

Ground/

Socket

1-1/2 to 2 inch

Floor

Clearance

 

FIGURE 7.1 Adjusting/Replacing Anti-tipper

Installing/Removing/Adjusting Swivel Anti-Tip

NOTE: For this procedure, refer to FIGURE 7.2.

NOTE: This applies to any Terminator ordered with swivel anti‐tip.

Installing/Depth Adjustment

1.Loosen set screws on anti‐tip receivers (FIGURE 7.2).

2.Slide the swivel anti‐tip into the anti‐tip receivers. Position swivel anti‐tip so it is even with wheels on chair or extends beyond them. Tighten set screws.

Removing

1.Loosen set screws on anti‐tip receivers (FIGURE 7.2).

2.Slide the swivel anti‐tip out of the receivers.

Page 67 Page 69
Image 68
Page 67 Page 69
Contents Everyday and Sport Series Wheelchairs Everyday and Sport Series Wheelchairs Table of Contents Wheels Suspension Register Your Product Complete and mail the form on the nextProduct Registration Form Fold Here Cut Along Line Special Notes Wheelchair TIE-DOWN Restraints and Seat Positioning StrapsTypical Product Parameters TerminatorTypical Product Parameters Terminator Titanium Titanium Paul Schulte Signature BB Transformer ALL-SPORT Operating Information General GuidelinesStability Warning General Guidelines Tire Pressure and Information Weight TrainingWeight Limitation Safe Handling Stability and BalancePercentage of Weight Distribution Coping with Everyday ObstaclesReaching, Leaning and Bending Forward Reaching, Leaning BackwardsTipping Tipping CurbsStairways Transferring To and From Other Seats Inspect Initially Safety InspectionSafety Inspection Checklist Inspect/Adjust Weekly Inspect/Adjust MonthlyTroubleshooting Inspect/Adjust PeriodicallySuggested Maintenance Procedures MaintenanceMaintenance Safety Precautions Safety Inspection Unfolding/Folding the Back Back Angle AdjustmentBack Back Angle Adjustment Removing Foldover Back Upholstery Removing/Installing Foldover Back UpholsteryInstalling Foldover Back Upholstery Adjustable Tension Back Upholstery Adjustable Tension StrapsReplacing Adjustable Tension Back Upholstery Back Upholstery CoverBack Height Adjustment Adjustable Backs Only Back Original Back Height in Inches Removing/Installing Rear Wheels WheelsAdjusting Quick-Release Axles Replacing Quad-Release AxlesRemoving Play from Rear Wheels Adjusting Quad-Release HandlesAnd/or Out Handrim Replacement Repairing/Replacing Rear Wheel, Tire/TubeOpening/Closing Camber Clamps Opening/Closing Camber Clamps A4 Camber System Adjusting Rear Wheel CamberCamber Tube Determining Toe In/Toe Out Adjusting Toe In/Toe Out Adjusting Toe In/Toe Out Camber TubeCourse Adjustment Fine Adjustment Adjusting Wheelbase Length Adjusting Center of Gravity 11 Adjusting Toe In/Toe Out A4 Camber System Fine Adjustment12 Adjusting Wheelbase Length Adjusting Center of Gravity Adjusting Wheelbase Width 13 Adjusting Wheelbase Width Camber Tube14 Adjusting Wheelbase Width A4 Camber System Replacing Axle TubeWheels Adjusting the Axle Tube 16 Adjusting the Axle Tube Camber Tube 17 Adjusting the Axle Tube A4 Camber System Replacing/Adjusting Casters Repeat Steps 1‐3 for the opposite caster if necessaryAdjusting Front Caster Height Parallel to the floorWheel Lock Adjustment/Replacement 20 Wheel Lock Adjustment/Replacement Replacing Adjustable Tension Seat Upholstery SeatReplacing Adjustable Tension Seat Upholstery Replacing Screw-On Seat UpholsteryAdjusting Rear Seat Height Adjusting Transformer Seat HeightAdjusting Front Seat Height Adjusting Transformer Seat Height Replacing the Footrest Adjusting the FootrestFootrest ANTI-TIPPER Installing/Adjusting Optional Clamp on Raised Footrest Replacing/Adjusting Optional A4 FootrestInstalling AdjustingAdjusting Footplate Depth Installing the X-Terminator FootrestAdjusting Footplate Angle Adjusting the X-terminator and Transformer Footrests DepthAngle Terminator HeightAdjusting/Replacing Anti-tipper Adjusting Anti-tipper Replacing Anti-tipperRemoving Installing/Removing/Adjusting Swivel Anti-TipInstalling/Depth Adjustment Adjusting Height Paul Schulte Signature BB and T-5 Tennis Elite Models onlySuspension Elastomers and Suspension Replacing Rear ElastomersReplacing Front Elastomers Replacing Rear ElastomersReplacing Front Elastomers Installing/Removing the Wing/Bumper WING/BUMPERWING/BUMPER Limited Warranty USA
Top Page Image Contents