SECTION
SECTION 9—WING/BUMPER
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise injury or damage may occur.
NOTE: The following procedures are for Transformer wheelchairs ONLY.
Installing/Removing the Wing/Bumper
NOTE: For this procedure, refer to FIGURE 9.1.
Installing
1.Slide wing/bumper clamps onto caster housing on the Transformer. Ensure the wing or bumper is even on both sides.
2.Tighten allen screws securely on each side.
Removing
1.Loosen allen screws on wing/bumper clamps.
2.Slide up and remove.
Bumper/Wing
Clamp
Wing/Bumper
Allen Screws
Caster Housing
FIGURE 9.1 Installing/Removing the Wing/Bumper
Part No 1114851 | 73 | Everyday and Sport Series Wheelchairs |