Invacare Paul Schulte Signature BB, X-Terminator QR Removing/Installing Foldover Back Upholstery

SECTION 4—BACK

Removing/Installing Foldover Back Upholstery

WARNING

The position of the footrest, seat angle, back angle, seating system/upholstery, caster size and position, rear wheel size and position, use of anti-tippers, as well as the user condition directly relate to the stability of the wheelchair. Any change to one or any combination of the ten may cause the wheelchair to decrease in stability. EXTREME care MUST be taken when changing the stability of the wheelchair. Refer to the chart in General Guidelines on page 15 of this manual.

NOTE: For this procedure, refer to FIGURE 4.3.

Removing Foldover Back Upholstery

1.Unfasten the two fastening flaps that secure the bottom of the existing back upholstery to the back canes.

2.Unfold the top of the back upholstery.

3.Lift up on the existing back upholstery and remove from the wheelchair.

Installing Foldover Back Upholstery

1. Install the new back upholstery onto

the back canes.

Back Upholstery

2.	Wrap the end of a fastening flap around
	the back cane.
3.	Insert the end of the fastening flap
	through the loop.
4.	Wrap the fastening flap around the
	back cane again and press firmly to

Fastening Strips

Front of

Wheelchair

Fold

Fastening

Flap

	secure.
5.	Fold the top of the back upholstery
	down over the back canes towards the
	front of the wheelchair.
6.	Press firmly to secure the fastening
	strips.

Fastening	Loops	Back
Flap
		Canes

FIGURE 4.3 Removing/Installing Foldover

Back Upholstery

Part No 1114851 31 Everyday and Sport Series Wheelchairs