SECTION
Top View of Wheelchair
Front of Wheelchair
Rear of
Wheelchair
Centerlines of Rear Wheels
Top View of Wheelchair
Front of Wheelchair
Smaller than
Front
Larger than Front
FIGURE 5.8 Determining Toe In/Toe Out - Measuring Centerlines of Rear Wheels
Adjusting Toe In/Toe Out
Camber Tube 2000
NOTE: For this procedure, refer to FIGURE 5.9.
1.Open the camber clamps. Refer to Opening/Closing Camber Clamps on page 39.
2.Slowly rotate the camber tube in either direction until the rear wheels are approximately in a straight line.
3.Close the camber clamps. Refer to Opening/Closing Camber Clamps on page 39.
4.Measure the distance between the center lines at the rear and front of the rear wheels at approximately 12 inches from the ground/floor. Refer to Determining Toe In/Toe Out on page 42.
5.Repeat STEPS 1‐4 until the toe in/toe out measurement is less than 1/2‐inch (0 + 1/4‐inch for maximum rollability).
Camber Tube - Rotates Up and Down
Camber Clamps
FIGURE 5.9 Adjusting Toe In/Toe Out -
Camber Tube 2000
Part No 1114851 | 43 | Everyday and Sport Series Wheelchairs |