SECTION
Adjusting the X-terminator and Transformer Footrests
NOTE: For this procedure, refer to FIGURE 7.4 and FIGURE 7.5.
Depth
1.Remove the four allen screws from the footrest and blocks.
2.Move footrest rearward or forward to desired depth.
3.Align the holes in the footrest with the holes in the blocks on footrest tubing.
4.Install allen screws into footrest and into the blocks.
5.Securely tighten the four allen screws.
Angle
1.Loosen the button screws on the blocks on bottom of the footrest tubing.
2.Adjust the angle of the footrest.
3.Retighten the button screws securely.
X-Terminator Height
1.Loosen the four allen screws.
2.Adjust clamp on raised footrest to the desired height.
3.Securely tighten the four allen screws.
Half Clamps | Allen |
Screws | |
| Footrest |
| Tubing |
Allen Screws | Footrest |
| Depth |
| Adjustment |
| Holes |
Button Screws | Blocks |
FIGURE 7.4 Installing the X-Terminator
Footrest - Adjusting the X-terminator and
Transformer Footrests
Transformer Height
NOTE: For this procedure, refer to FIGURE 7.5.
1.Note the order of the mounting screw, coved washers, spacer, half clamps and mounting screw/threaded sleeve and their position on the wheelchair frame and footrest tubing.
2.Remove the mounting screw, coved washers, spacer, half clamps and mounting screw/threaded sleeve on both sides of the wheelchair.
3.Choose an adjustment hole on the footrest tubing that will raise or lower the footrest to the desired position.
4.Reinstall the mounting screw, coved washers, spacer, half clamps and mounting screw/threaded sleeve on both sides of the wheelchair.
5.Securely tighten.
Part No 1114851 | 65 | Everyday and Sport Series Wheelchairs |