Invacare Terminator BB, X-Terminator QR Unfolding/Folding the Back, Back Angle Adjustment

Page 29

SECTION 4—BACK

SECTION 4—BACK

WARNING

ALWAYS perform these procedures in the presence of an assistant. The position of the footrest, camber tube, back angle, the tautness of the back upholstery as well as the user's condition are directly related to the wheelchairs stability. Any change to one or any combination of the five may cause the wheelchair to decrease in stability. Use EXTREME caution when using a new seating position. The addition of anti-tippers may be required.

After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may occur.

Unfolding/Folding the Back

WARNING

Back MUST be locked securely in place before using the wheelchair.

NOTE: For this procedure, refer to FIGURE 4.1

1.To unfold the back, lift up on the back canes and pull back towards the rear of the wheelchair until it locks into place.

2.To fold the back, pull up on the back release cord and push the back canes forward toward the front of the wheelchair.

Rear of

Front of

Wheelchair

Wheelchair

Back Cane

NOTE: Back upholstery

removed for clarity.

Back Release Cord

(Not Shown)

FIGURE 4.1 Unfolding/Folding the Back

Back Angle Adjustment

NOTE: For this procedure, refer to FIGURE 4.2

NOTE: Perform this procedure on both sides of the wheelchair at the same time.

Part No 1114851

29

Everyday and Sport Series Wheelchairs

Image 29
Contents Everyday and Sport Series Wheelchairs Everyday and Sport Series Wheelchairs Table of Contents Wheels Suspension Complete and mail the form on the next Register Your ProductProduct Registration Form Fold Here Cut Along Line Wheelchair TIE-DOWN Restraints and Seat Positioning Straps Special NotesTerminator Typical Product ParametersTypical Product Parameters Terminator Titanium Titanium Paul Schulte Signature BB Transformer ALL-SPORT Operating Information General GuidelinesStability Warning General Guidelines Tire Pressure and Information Weight TrainingWeight Limitation Stability and Balance Safe HandlingCoping with Everyday Obstacles Percentage of Weight DistributionReaching, Leaning Backwards Reaching, Leaning and Bending ForwardTipping Curbs TippingStairways Transferring To and From Other Seats Inspect Initially Safety InspectionSafety Inspection Checklist Inspect/Adjust Monthly Inspect/Adjust WeeklyInspect/Adjust Periodically TroubleshootingSuggested Maintenance Procedures MaintenanceMaintenance Safety Precautions Safety Inspection Unfolding/Folding the Back Back Angle AdjustmentBack Back Angle Adjustment Removing Foldover Back Upholstery Removing/Installing Foldover Back UpholsteryInstalling Foldover Back Upholstery Adjustable Tension Straps Adjustable Tension Back UpholsteryReplacing Adjustable Tension Back Upholstery Back Upholstery CoverBack Height Adjustment Adjustable Backs Only Back Original Back Height in Inches Wheels Removing/Installing Rear WheelsReplacing Quad-Release Axles Adjusting Quick-Release AxlesRemoving Play from Rear Wheels Adjusting Quad-Release HandlesAnd/or Out Repairing/Replacing Rear Wheel, Tire/Tube Handrim ReplacementOpening/Closing Camber Clamps Opening/Closing Camber Clamps A4 Camber System Adjusting Rear Wheel CamberCamber Tube Determining Toe In/Toe Out Adjusting Toe In/Toe Out Camber Tube Adjusting Toe In/Toe OutCourse Adjustment Fine Adjustment 11 Adjusting Toe In/Toe Out A4 Camber System Fine Adjustment Adjusting Wheelbase Length Adjusting Center of Gravity12 Adjusting Wheelbase Length Adjusting Center of Gravity 13 Adjusting Wheelbase Width Camber Tube Adjusting Wheelbase WidthReplacing Axle Tube 14 Adjusting Wheelbase Width A4 Camber SystemWheels Adjusting the Axle Tube 16 Adjusting the Axle Tube Camber Tube 17 Adjusting the Axle Tube A4 Camber System Repeat Steps 1‐3 for the opposite caster if necessary Replacing/Adjusting CastersParallel to the floor Adjusting Front Caster HeightWheel Lock Adjustment/Replacement 20 Wheel Lock Adjustment/Replacement Seat Replacing Adjustable Tension Seat UpholsteryReplacing Screw-On Seat Upholstery Replacing Adjustable Tension Seat UpholsteryAdjusting Rear Seat Height Adjusting Transformer Seat HeightAdjusting Front Seat Height Adjusting Transformer Seat Height Replacing the Footrest Adjusting the FootrestFootrest ANTI-TIPPER Replacing/Adjusting Optional A4 Footrest Installing/Adjusting Optional Clamp on Raised FootrestInstalling AdjustingAdjusting Footplate Depth Installing the X-Terminator FootrestAdjusting Footplate Angle Depth Adjusting the X-terminator and Transformer FootrestsAngle Terminator HeightAdjusting/Replacing Anti-tipper Replacing Anti-tipper Adjusting Anti-tipperRemoving Installing/Removing/Adjusting Swivel Anti-TipInstalling/Depth Adjustment Paul Schulte Signature BB and T-5 Tennis Elite Models only Adjusting HeightElastomers and Suspension Replacing Rear Elastomers SuspensionReplacing Rear Elastomers Replacing Front ElastomersReplacing Front Elastomers WING/BUMPER Installing/Removing the Wing/BumperWING/BUMPER Limited Warranty USA