Invacare Torque SP, Arrow, Ranger X service manual Back Angle Adjustment Figure

PROCEDURE 8 BACK FRAME

BACK ANGLE ADJUSTMENT (FIGURE 3)

1. Remove armrests from the wheelchair. Refer to IN-

BSTALLING/REMOVING FLIP BACKARMRESTS in

APROCEDURE 4 of the owner’s manual, 1081227.

C2. Remove the mounting screw and washer from the top

Kmounting hole of back angle plate and back cane.

FNOTE:Toavoidlosingtheinsertineachbackcane,thread

Rthe mounting screw through the cane from the inside of

Awheelchair to hold the insert in place.

M

E

3.Remove the mounting screw and washer from the bottom mounting hole of the back angle plate and back cane.

4.Reposition the back canes into the correct mount-

ing holes of the back angle plate to obtain a back angle between 80o and 100o in 5o increments.

5.Torque mounting screws to 75-inch pounds.

6.Reinstall the armrests onto the wheelchair. Refer to INSTALLING/REMOVING FLIP BACK ARM- RESTS in PROCEDURE 4 of the owner’s manual, 1081227.

TO ACHIEVE A BACK ANGLE OF:

ANGLE	BACK CANE MOUNTING HOLE	BACK ANGLE PLATE HOLE
80O	Top	TOP Front
	Bottom	BOTTOM Rear

85O	Top	TOP Front
	2nd from Bottom	BOTTOM Center

90O	Top	TOP Front
	Bottom	BOTTOM Front

95O	Top	TOP Center
	2nd from Bottom	BOTTOM Front

100O	Top	TOP Rear
	Bottom	BOTTOM Front

FIGURE 3 - BACK ANGLE ADJUSTMENT

40