Invacare Arrow, Ranger X REMOVING/INSTALLING ANTI-TIP Assembly, Anti-Tip, Lower, Washers Locknuts

PROCEDURE 16 RWD WHEELCHAIRS

REMOVING/INSTALLING THE

ANTI-TIP ASSEMBLY

R

WRemoving

D1. Remove the mounting screw, washers, and spacers

Wthat secure the top of the anti-tip bracket to the suspen-

sion arm.H

E	2. Remove the mounting screw and locknut that secure
E	the extension spring in place.
L

C3. Remove the mounting screw, washers, and spacers

Hthat secure the bottom of the anti-tip bracket to the sus-

Apension arm.

I

RInstalling

S

1.Aligntopmountingholeofanti-tipbracketwithtopmount- ing slot in rear of suspension arm.

2.Secure top of anti-tip bracket to suspension arm with existing mounting screw, washers, spacers, and lock- nut. Securely tighten.

3.Alignlowermountingholeoftheanti-tipmountingbracket with the lower slot of the suspension arm.

4.Secure the anti-tip bracket to the suspension arm with the existing mounting screw, washers, spac- ers, and locknuts. Securely tighten.

5.Hook one end of the extension spring around mounting screw.

6.Install mounting screw through lower mounting hole in suspension arm, other end of extension spring and opposite side of suspension arm. Se- curely tighten with locknut.

	Top
	Mounting
Anti-Tip	Hole
Bracket		Spacers
DO NOT
USE THIS
MOUNTING
HOLE
Lower
Mounting
Hole
Extension
Spring
Mounting
Screws
DO NOT	Lower
USE THIS	Mounting	Mounting
MOUNTING	Slot	Screw
SLOT

Washers Locknuts

Locknut

DO NOT

USE THIS

MOUNTING

HOLE

Lower

Mounting

Hole

Suspension

Arm

DO NOT use this mounting hole. This mounting hole is used to secure the shock assembly.

NOTE: Suspension arm shown is for gearless/brushless motor. The Anti-tip assembly removes/installs in the same manner on the suspension arm used with the conventional motor/gearbox assembly.

FIGURE 17 - REMOVING/INSTALLING THE ANTI-TIP ASSEMBLY

90