Invacare Torque SP Procedure MWD Wheelchairs, Front Locknuts Battery Mount, Frame Rear Locknuts

PROCEDURE 15 MWD WHEELCHAIRS

M

W D

W H E E L C H A

Installing

1.Install battery box tray onto base frame.

2.Secure the front of the battery box tray to battery mount brackets with existing locknuts. Torque to 160-inch pounds.

3.Secure the rear of the battery box tray to the base frame with existing mounting screws and locknuts. Torque to 160-inch pounds.

4.Reinstallthebatterybox.RefertoINSTALLING/REMOV- ING GROUP 22 BATTERY BOX in PROCEDURE 9 of this manual.

3.Disconnect the right and left motor connectors from the controller connectors.

4.Remove the two (2) mounting screws that secure the charger cable to the mount bracket.

5.Remove the charger cable from the mount bracket.

5.Cut the tie-wrap that secures the wiring harness to the seat frame.

6.Remove the wiring harness.

7.Remove the four (4) mounting screws that secure the battery mount brackets to the base frame and remove the battery mount brackets.

I

R S

Front Locknuts	Battery Mount
FRONT OF	Bracket
CHAIR	Mounting
	Screws

		REAR OF
Battery	Base	CHAIR
Box Tray	Frame	Rear Locknuts

FIGURE 2 - REMOVING/INSTALLING GROUP 22

BATTERY BOX TRAY

EQUIPMENT OPTION

CONVERTING GROUP 22 BATTERY BOX TRAY TO GROUP 24 BATTERY BOX SUB FRAME

NOTE: The battery box tray and battery mount brackets will notbeusedwiththisoption.Keepforfutureuse.

Removing Group 22 Components (FIGURE 3)

1.Remove the battery box. Refer to INSTALLING/RE- MOVING GROUP 22 BATTERY BOX in PROCE- DURE 9 of this manual.

2.Removetheexistingbatteryboxtray.RefertoREMOV-

ING/INSTALLING THE GROUP 22 BATTERY BOX TRAY in this procedure of the manual.

Tie Wrap

Charger Cable/

Bracket

Motor

Connector

Motor Connector

Spacer

Locknut

Mounting

Screws

Base Frame

Shock

Battery Mount Bracket

FIGURE 3 - REMOVING GROUP 22 COMPONENTS

Installing Group 24 Components (FIGURE 4)

1.Align the mounting holes of the NEW wiring harness w/bracket, the NEW battery box sub-frame and the mounting holes in the base frame.

2.Install the two (2) mounting screws through all three (3) parts and secure with locknuts. Torque to 160-inch pounds.

70