Invacare IMX1 Carefully slide the rigidizer bracket onto the band clamp, Band clamp in place

Page 10

3 MONO MOUNT

4.

Position the rigidizer bracket B at a 45° angle to the band clamp.

5.

Align the edges of the clamp with the corresponding slots F in the

 

rigidizer bracket.

OPTIONAL INVERTED POSITION

FOR 9” (23 CM) TALL BACKS

6.

Carefully slide the rigidizer bracket onto the band clamp.

7.

Ensure the clamp is fully engaged in the slots in the rigidizer bracket.

8.

Insert the two locking pins G into the rigidizer bracket to hold the

 

band clamp in place.

9.

Ensure the pins are fully inserted into the rigidizer bracket.

D E 3

F

The pins should slide into position with little effort. If the

pins are difficult to insert, verify that the band clamp is

 

properly centered and fully seated inside the slots of the

 

rigidizer bracket.

B

STANDARD

INSTALLATION

 

4

5

 

D

8

E 3 F

G

B

G

Invacare® Matrx® MX1

10

Part No. 1171914

Image 10
Contents Invacare Matrx MX1 Model IMX1Invacare Matrx MX1 Contents Overview Important Information SymbolsGeneral Invacare Matrx MX1Limited Warranty North America Outer CoverGeneral Guidelines SafetyInstallation Information Intended UseWeight Limitation and Model NumbersWARNING Operating InformationMono Mount Installation OverviewBefore Installation Included ItemsInstalling the Mounting Hardware Inch 23 cm Tall MX1 Back Cushions OnlyCarefully slide the rigidizer bracket onto the band clamp Band clamp in placeInstalling the Tracking Plate on the Back Shell Installing the Back Shell onto the Mounting Hardware Adjusting the Back HeightAdjusting the Back Angle Removing the Mono Mount Hardware Our customer service department Fixed Dual MountClamp Body Adjustment Repeat Steps 1-3 for the opposite sideInstalling the Band Clamps Installing the BackFixed Dual Mount Adjust the back to the desired height Loosen the compression bar hardware aAfter Installation Adjusting the Back Angle and Back DepthLoosen the screws a on the side of both clamp bodies B Quick Release Dual Mount Loosening the Compression Bar Securing the Clamp Body to the Band Clamp Securing the Clamp Body Assembly to the Back Cane Inside View Adjusting the Back Height Removing the Back Cushion Adhesive Pads Installing/Adjusting the Lumbar Support Plug InsertsOptions Mounting holes B on the back shell CInstalling the Optional Privacy Flap WidthLaundering MaintenanceCleaning General Cleaning InspectionUsability Survey TRD0283 USA