3 MONO MOUNT
3.6Installing the Back Shell onto the Mounting Hardware
1. | If necessary, disengage the outer cover hook and loop strip at the |
| bottom rear of the back (not shown). |
2. | Loosen the two locking wedge washers A on each side of the |
| rigidizer bracket B. |
3. | Align the notched channel C in the bracket with the corresponding |
| raised area D on the mounting rail E. |
4. | Slide the mounting rail onto the rigidizer bracket. |
5. | Adjust the back cushion to the desired height along the channels in |
| the mounting rail. |
6. | Tighten the locking wedge washers on each side of the rigidizer |
| bracket to secure the back into position. |
7. | Adjust the back height. Refer to Adjusting the Back Height on |
3.7Adjusting the Back Height
9-inch (23 cm) Tall MX1 Back Cushions Only:
In order to optimize the available height adjustment on the back cushion, it may be necessary to invert the rigidizer bracket during installation. Refer to Installing the Mounting Hardware on page 9.
1.Loosen the two locking wedge washers A on each side of the rigidizer bracket B.
2.Adjust the back cushion to the desired height along the channels in the mounting rail C.
3.Tighten the locking wedge washers on each side of the rigidizer bracket to secure the back into position.
4.Adjust the back angle. Refer to Adjusting the Back Angle.
page 12. |
2 & 6 |
|
| E |
|
|
|
| D | |
|
|
|
|
|
| ||||
TOP VIEW |
|
|
|
|
|
| |||
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| |||
A |
| A |
|
|
|
|
|
| C |
|
|
|
|
|
|
| |||
|
|
|
|
| |||||
|
|
|
|
|
|
| A | ||
B |
|
| B |
|
|
|
|
| |
|
|
|
|
|
|
|
| ||
\
2
A B A
2
C
Invacare® Matrx® MX1 | 12 | Part No. 1171914 |