Invacare IMX1 user manual Loosening the Compression Bar

Page 22

5 QUICK RELEASE DUAL MOUNT

5.4Installing the Adjustable Mounting Brackets onto the Back Shell

1.Remove any existing wheelchair back, back upholstery or back cane hardware.

2.Remove the four hex screws A and washers (not shown) securing the two backing plates B to the adjustable mounting bracket C.

3.Align the adjustable mounting bracket with the slots D on one side of the back shell E.

The adjustable mounting bracket should be oriented with the four slots F against the back shell.

4.Place the four washers onto the hex screws.

5.Loosely attach the adjustable mounting bracket to the back shell using the two backing plates, four hex screws and four washers. Do not tighten the hex screws at this time.

6.Repeat STEPS 2-5 for the other bracket.

5.5Loosening the Compression Bar

1.Loosen the two screws A securing the compression bar B to the clamp body C.

Loosening the compression bar allows the clamp body to sit flush against the back cane D prior to installation (Detail A).

DETAIL A	C B	D

B

D A

A

F

C D B

E

Invacare® Matrx® MX1

22

Part No. 1171914

Image 22

Contents Invacare Matrx MX1 Model IMX1Invacare Matrx MX1 Contents Overview Important Information SymbolsGeneral Invacare Matrx MX1Limited Warranty North America Outer CoverGeneral Guidelines SafetyInstallation Information Intended UseWeight Limitation and Model NumbersWARNING Operating InformationMono Mount Installation OverviewBefore Installation Included ItemsInstalling the Mounting Hardware Inch 23 cm Tall MX1 Back Cushions OnlyCarefully slide the rigidizer bracket onto the band clamp Band clamp in placeInstalling the Tracking Plate on the Back Shell Installing the Back Shell onto the Mounting Hardware Adjusting the Back HeightAdjusting the Back Angle Removing the Mono Mount Hardware Our customer service department Fixed Dual MountClamp Body Adjustment Repeat Steps 1-3 for the opposite sideInstalling the Band Clamps Installing the BackFixed Dual Mount Adjust the back to the desired height Loosen the compression bar hardware aAfter Installation Adjusting the Back Angle and Back DepthLoosen the screws a on the side of both clamp bodies B Quick Release Dual Mount Loosening the Compression Bar Securing the Clamp Body to the Band Clamp Securing the Clamp Body Assembly to the Back Cane Inside View Adjusting the Back Height Removing the Back Cushion Adhesive Pads Installing/Adjusting the Lumbar Support Plug InsertsOptions Mounting holes B on the back shell CInstalling the Optional Privacy Flap WidthLaundering MaintenanceCleaning General Cleaning InspectionUsability Survey TRD0283 USA