Invacare IMX1 user manual Installing the Band Clamps, Installing the Back

Page 17

4.6Installing the Band Clamps

1.Install the two band clamps A onto the back canes B of the wheelchair.

Allow the band clamps to rest on the rigidizer bar C.

B

CA

4.7Installing the Back

1.Align and insert the tabs A on the band clamp B with the slots C in the clamp body D.

2.Ensure the band clamp is fully inserted into the clamp body.

D

A

CB

4 FIXED DUAL MOUNT

3.Loosen the compression bar hardware E, so the clamp body rests flush against the back cane.

￿ WARNING

DO NOT adjust the center screw in the clamp body. The center screw F is designed only to hold the compression bar in place during installation. Adjusting this screw may prevent the compression bar from tightening properly onto the back cane.

4.Insert the two locking pins G into the clamp body to lock the band clamp in position.

The pins should slide into position with little effort. If the pins are difficult to insert, verify that the band clamp is properly centered and fully seated inside the slots H of the clamp body.

5.Ensure both locking pins are fully inserted.

\

H

EG F

Part No. 1171914

17

Invacare® Matrx® MX1

Image 17
Contents Model IMX1 Invacare Matrx MX1Invacare Matrx MX1 Contents General SymbolsOverview Important Information Invacare Matrx MX1Outer Cover Limited Warranty North AmericaInstallation Information SafetyGeneral Guidelines Intended UseOperating Information Weight Limitation and Model NumbersWARNINGBefore Installation Installation OverviewMono Mount Included ItemsInch 23 cm Tall MX1 Back Cushions Only Installing the Mounting HardwareBand clamp in place Carefully slide the rigidizer bracket onto the band clampInstalling the Tracking Plate on the Back Shell Adjusting the Back Height Installing the Back Shell onto the Mounting HardwareAdjusting the Back Angle Removing the Mono Mount Hardware Fixed Dual Mount Our customer service departmentRepeat Steps 1-3 for the opposite side Clamp Body AdjustmentInstalling the Back Installing the Band ClampsFixed Dual Mount Loosen the compression bar hardware a Adjust the back to the desired heightLoosen the screws a on the side of both clamp bodies B Adjusting the Back Angle and Back DepthAfter Installation Quick Release Dual Mount Loosening the Compression Bar Securing the Clamp Body to the Band Clamp Securing the Clamp Body Assembly to the Back Cane Inside View Adjusting the Back Height Removing the Back Cushion Options Installing/Adjusting the Lumbar Support Plug InsertsAdhesive Pads Mounting holes B on the back shell CWidth Installing the Optional Privacy FlapCleaning General Cleaning MaintenanceLaundering InspectionUsability Survey USA TRD0283