Invacare IMX1 user manual Installing the Tracking Plate on the Back Shell

Page 11

10. Center the bracket between the back canes.

11. Tighten the compression bar hardware A just snug enough to hold the bracket assembly in place.

￿ WARNING

DO NOT adjust the center screw in the rigidizer bracket. The center screw B is designed only to hold the compression bar in place during installation. Adjusting this screw may prevent the compression bar from tightening properly onto the back cane.

Do not fully tighten the compression bar at this time.

12.Install the tracking plate. Refer to Installing the Tracking Plate on the Back Shell on page 11.

11B

A

A

3 MONO MOUNT

3.5Installing the Tracking Plate on the Back Shell

1.Disengage the cover (not shown) from the top and bottom of the back shell A.

2.Remove the cushion and cover from the back shell.

3.Secure the tracking plate B to the back using the four screws C, washers (not shown) and nuts (not shown). Tighten securely.

4.Secure the cushion and cover to the top of the back shell.

5.Secure the cushion and cover to the inside of the back shell.

6.Install the back shell.

C

B A

Part No. 1171914

11

Invacare® Matrx® MX1

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Model IMX1 Invacare Matrx MX1Invacare Matrx MX1 Contents Invacare Matrx MX1 SymbolsGeneral Overview Important InformationOuter Cover Limited Warranty North AmericaIntended Use SafetyInstallation Information General GuidelinesOperating Information Weight Limitation and Model NumbersWARNINGIncluded Items Installation OverviewBefore Installation Mono MountInch 23 cm Tall MX1 Back Cushions Only Installing the Mounting HardwareBand clamp in place Carefully slide the rigidizer bracket onto the band clampInstalling the Tracking Plate on the Back Shell Adjusting the Back Height Installing the Back Shell onto the Mounting HardwareAdjusting the Back Angle Removing the Mono Mount Hardware Fixed Dual Mount Our customer service departmentRepeat Steps 1-3 for the opposite side Clamp Body AdjustmentInstalling the Back Installing the Band ClampsFixed Dual Mount Loosen the compression bar hardware a Adjust the back to the desired heightLoosen the screws a on the side of both clamp bodies B Adjusting the Back Angle and Back DepthAfter Installation Quick Release Dual Mount Loosening the Compression Bar Securing the Clamp Body to the Band Clamp Securing the Clamp Body Assembly to the Back Cane Inside View Adjusting the Back Height Removing the Back Cushion Mounting holes B on the back shell C Installing/Adjusting the Lumbar Support Plug InsertsOptions Adhesive PadsWidth Installing the Optional Privacy FlapInspection MaintenanceCleaning General Cleaning LaunderingUsability Survey USA TRD0283
Top Page Image Contents