Invacare IMX1 Loosen the compression bar hardware a, Adjust the back to the desired height

Page 19

8.Adjust the back shell J so it is centered between the back canes K.

9.Tighten the eight screws L securing the angle adjustable brackets I to the back shell.

L

J

K

K

4 FIXED DUAL MOUNT

4.8Adjusting the Back Height

1.Loosen the compression bar hardware A.

￿ WARNING

DO NOT adjust the center screw in the clamp body. The center screw B is designed only to hold the compression bar in place during installation. Adjusting this screw may prevent the compression bar from tightening properly onto the back cane.

2.Adjust the back to the desired height.

Heightcanes. adjustments must be made equally on both back

3.Tighten the compression bar hardware to secure the clamp bodies C in place.

When re-tightening the compression bar hardware, alternate back and forth between the screws until the compression bar is fully secured.

C

BA

Part No. 1171914

19

Invacare® Matrx® MX1

Image 19
Contents Model IMX1 Invacare Matrx MX1Invacare Matrx MX1 Contents Invacare Matrx MX1 SymbolsGeneral Overview Important InformationOuter Cover Limited Warranty North AmericaIntended Use SafetyInstallation Information General GuidelinesOperating Information Weight Limitation and Model NumbersWARNINGIncluded Items Installation OverviewBefore Installation Mono MountInch 23 cm Tall MX1 Back Cushions Only Installing the Mounting HardwareBand clamp in place Carefully slide the rigidizer bracket onto the band clampInstalling the Tracking Plate on the Back Shell Adjusting the Back Height Installing the Back Shell onto the Mounting HardwareAdjusting the Back Angle Removing the Mono Mount Hardware Fixed Dual Mount Our customer service departmentRepeat Steps 1-3 for the opposite side Clamp Body AdjustmentInstalling the Back Installing the Band ClampsFixed Dual Mount Loosen the compression bar hardware a Adjust the back to the desired heightAfter Installation Adjusting the Back Angle and Back DepthLoosen the screws a on the side of both clamp bodies B Quick Release Dual Mount Loosening the Compression Bar Securing the Clamp Body to the Band Clamp Securing the Clamp Body Assembly to the Back Cane Inside View Adjusting the Back Height Removing the Back Cushion Mounting holes B on the back shell C Installing/Adjusting the Lumbar Support Plug InsertsOptions Adhesive PadsWidth Installing the Optional Privacy FlapInspection MaintenanceCleaning General Cleaning LaunderingUsability Survey USA TRD0283