Invacare IMX1 user manual Installing the Optional Privacy Flap, Width

Page 29

6.4Installing the Optional Privacy Flap

Privacy flaps A are available (sold separately) for use with all standard sized MX1 backs. All standard sized backs come with a pre-sewn loop strip across the bottom rear of the cushion cover B for installation of the privacy flap.

Refer to the chart for proper sizing of the privacy flap for the MX1 back.

WIDTH

PRIVACY FLAP

14 in (36 cm)

PFLAP-XS

 

10” x 16” (26 cm x 41 cm)

 

 

15 in (38 cm)

PFLAP-S

16 in (41 cm)

13” x 16” (33 cm x 41 cm)

17 in (43 cm)

PFLAP-M

 

15” x 16” (38 cm x 41 cm)

18 in (46 cm)

1.If installed, remove the seat cushion.

2.Ensure the back is adjusted to the desired height. Refer to Adjusting the Back Height on page 12, Adjusting the Back Height on page 19 or Adjusting the Back Height on page 26.

3.Position the wheelchair in front of you so the back is facing you.

4.Align the hook strip C on the privacy flap with the loop strip sewn on to the bottom rear of the back cover.

5.Pull the opposite end of the privacy flap through the gap between the back and the wheelchair seat D.

6.Secure the loop strip E on the opposite end of the privacy flap to the fastening strip on the wheelchair seat.

The fastening strip pre-installed on the wheelchair seat pan or sling upholstery may be either a hook strip or a loop strip. It may be necessary to install the the double sided hook strip F onto the privacy flap to secure it to the seat.

Detail A

AC

F

6 OPTIONS

Rear View

1-3

DB

4

B A C

Front View

5A

E

D

A

F 6 D

Part No. 1171914

29

Invacare® Matrx® MX1

Image 29
Contents Model IMX1 Invacare Matrx MX1Invacare Matrx MX1 Contents General SymbolsOverview Important Information Invacare Matrx MX1Outer Cover Limited Warranty North AmericaInstallation Information SafetyGeneral Guidelines Intended UseOperating Information Weight Limitation and Model NumbersWARNINGBefore Installation Installation OverviewMono Mount Included ItemsInch 23 cm Tall MX1 Back Cushions Only Installing the Mounting HardwareBand clamp in place Carefully slide the rigidizer bracket onto the band clampInstalling the Tracking Plate on the Back Shell Adjusting the Back Height Installing the Back Shell onto the Mounting HardwareAdjusting the Back Angle Removing the Mono Mount Hardware Fixed Dual Mount Our customer service departmentRepeat Steps 1-3 for the opposite side Clamp Body AdjustmentInstalling the Back Installing the Band ClampsFixed Dual Mount Loosen the compression bar hardware a Adjust the back to the desired heightLoosen the screws a on the side of both clamp bodies B Adjusting the Back Angle and Back DepthAfter Installation Quick Release Dual Mount Loosening the Compression Bar Securing the Clamp Body to the Band Clamp Securing the Clamp Body Assembly to the Back Cane Inside View Adjusting the Back Height Removing the Back Cushion Options Installing/Adjusting the Lumbar Support Plug InsertsAdhesive Pads Mounting holes B on the back shell CWidth Installing the Optional Privacy FlapCleaning General Cleaning MaintenanceLaundering InspectionUsability Survey USA TRD0283