5.6Installing the Band Clamps
1.Install the two band clamps A onto the back canes B of the wheelchair.
2.Install the clamp body C onto the band clamp at a 45° angle by aligning the edges of the clamp with the corresponding slots D in the clamp body.
3.Carefully slide the two components together.
4.Ensure that the clamp is fully inserted inside the slots on the clamp body.
D A 
B
C 
5 QUICK RELEASE DUAL MOUNT
5.7Securing the Clamp Body to the Band Clamp
1.Insert the two locking pins A into the clamp body B to secure it to the band clamp C.
The pins should slide into position with little effort. If pins are difficult to insert, verify that the band clamp is properly centered and fully inserted inside the slots of the mounting bracket.
2.Ensure the pins are fully seated into the clamp body.
3.Repeat STEPS
B
C
A
Part No. 1171914 | 23 | Invacare® Matrx® MX1 |