Invacare IMX1 user manual Removing the Mono Mount Hardware

Page 14

3 MONO MOUNT

3.9Removing the Mono Mount Hardware

1.Open the cushion cover at the bottom of the back cushion (not shown).

C D

4 G

2.Loosen the locking wedge washers A on either side of the rigidizer bracket B.

3.Slide the back cushion C upward until the mounting rail D is disengaged from the rigidizer bracket.

4.Loosen the compression bar hardware E to loosen the band clamp F.

WARNING

DO NOT adjust the center screw in the rigidizer bracket. The center screw C is designed only to hold the compression bar in place during installation. Adjusting this screw may prevent the compression bar from tightening properly onto the back cane.

	E		H
			5
	3
	2
	A A	I
	B	I	F
	B	6

5.Use a hex key H to push out the locking pins I from the rigidizer bracket.

6.Separate the rigidizer bracket from the band clamp.

Invacare® Matrx® MX1

14

Part No. 1171914

Image 14

Contents Invacare Matrx MX1 Model IMX1Invacare Matrx MX1 Contents Overview Important Information SymbolsGeneral Invacare Matrx MX1Limited Warranty North America Outer CoverGeneral Guidelines SafetyInstallation Information Intended UseWeight Limitation and Model NumbersWARNING Operating InformationMono Mount Installation OverviewBefore Installation Included ItemsInstalling the Mounting Hardware Inch 23 cm Tall MX1 Back Cushions OnlyCarefully slide the rigidizer bracket onto the band clamp Band clamp in placeInstalling the Tracking Plate on the Back Shell Installing the Back Shell onto the Mounting Hardware Adjusting the Back HeightAdjusting the Back Angle Removing the Mono Mount Hardware Our customer service department Fixed Dual MountClamp Body Adjustment Repeat Steps 1-3 for the opposite sideInstalling the Band Clamps Installing the BackFixed Dual Mount Adjust the back to the desired height Loosen the compression bar hardware aLoosen the screws a on the side of both clamp bodies B Adjusting the Back Angle and Back DepthAfter Installation Quick Release Dual Mount Loosening the Compression Bar Securing the Clamp Body to the Band Clamp Securing the Clamp Body Assembly to the Back Cane Inside View Adjusting the Back Height Removing the Back Cushion Adhesive Pads Installing/Adjusting the Lumbar Support Plug InsertsOptions Mounting holes B on the back shell CInstalling the Optional Privacy Flap WidthLaundering MaintenanceCleaning General Cleaning InspectionUsability Survey TRD0283 USA