Invacare IMX1 user manual Adjusting the Back Angle

Page 13

3.8Adjusting the Back Angle

1.Loosen the compression bar hardware A.

2.Rotate the back cushion B around the rigidizer bar C to the desired position.

3.Tighten the compression bar hardware to secure the back cushion in position.

WARNING

DO NOT adjust the center screw in the rigidizer bracket. The center screw D is designed only to hold the compression bar in place during installation. Adjusting this screw may prevent the compression bar from tightening properly onto the back cane.

When tightening the compression bar hardware, alternate back and forth between the two mounting screws to ensure the compression bar is fully secured.

4.Verify that all mounting hardware is properly tightened and the back is held firmly in place on the rigidizer bar.

3 MONO MOUNT

DB

1 & 3

A

C

Part No. 1171914

13

Invacare® Matrx® MX1

Image 13

Contents Model IMX1 Invacare Matrx MX1Invacare Matrx MX1 Contents General SymbolsOverview Important Information Invacare Matrx MX1Outer Cover Limited Warranty North AmericaInstallation Information SafetyGeneral Guidelines Intended UseOperating Information Weight Limitation and Model NumbersWARNINGBefore Installation Installation OverviewMono Mount Included ItemsInch 23 cm Tall MX1 Back Cushions Only Installing the Mounting HardwareBand clamp in place Carefully slide the rigidizer bracket onto the band clampInstalling the Tracking Plate on the Back Shell Adjusting the Back Height Installing the Back Shell onto the Mounting HardwareAdjusting the Back Angle Removing the Mono Mount Hardware Fixed Dual Mount Our customer service departmentRepeat Steps 1-3 for the opposite side Clamp Body AdjustmentInstalling the Back Installing the Band ClampsFixed Dual Mount Loosen the compression bar hardware a Adjust the back to the desired heightAfter Installation Adjusting the Back Angle and Back DepthLoosen the screws a on the side of both clamp bodies B Quick Release Dual Mount Loosening the Compression Bar Securing the Clamp Body to the Band Clamp Securing the Clamp Body Assembly to the Back Cane Inside View Adjusting the Back Height Removing the Back Cushion Options Installing/Adjusting the Lumbar Support Plug InsertsAdhesive Pads Mounting holes B on the back shell CWidth Installing the Optional Privacy FlapCleaning General Cleaning MaintenanceLaundering InspectionUsability Survey USA TRD0283