Invacare IMX1 user manual Maintenance, Cleaning General Cleaning, Laundering, Inspection, Reuse

Page 30

7 MAINTENANCE

7 Maintenance

7.1Cleaning

General Cleaning

1.Wipe the outer cover with a damp cloth when necessary.

Laundering

1.

Release the hook and loop fasteners securing the back cushion

 

cover. The hook and loop fasteners are located on the top and

 

bottom edge and inside of the back shell.

2.

Remove the foam cushion.

3.

Remove the lumbar support. Refer to Installing/Adjusting the

 

Lumbar Support on page 28.

4.

Remove the cover from the back shell.

7.2Inspection

WARNING

￿Check ALL fasteners weekly to ensure that mechanical connections and attaching hardware are tightened securely - otherwise injury or damage may occur.

DO NOT continue to use this product if problems are discovered. Corrective maintenance can be performed at or arranged through your equipment supplier.

Visually inspect parts including hardware, brackets, upholstery materials, foams (if accessible), and plastics, for deformation, corrosion, breakage, wear or compression.

5.

Follow the washing instructions on the cover.

6.

Allow the cover to fully dry.

7.

Insert the foam cushion into the cover.

8.

Ensure the foam cushion is fully inserted and the perimeter of the

 

foam is aligned with the cover seams.

9.

Install the cover onto the back shell.

10.

Install the lumbar support. Refer to Installing/Adjusting the Lumbar

 

Support on page 28.

7.3Reuse

￿

WARNING: Risk of Injury

Always have a dealer inspect the product for damage before transferring the product to a different user. If any damage is found, DO NOT use the product.

Otherwise injury may occur.

Invacare® Matrx® MX1

30

Part No. 1171914

Page 29 Page 31
Image 30
Page 29 Page 31
Contents Invacare Matrx MX1 Model IMX1Invacare Matrx MX1 Contents Overview Important Information SymbolsGeneral Invacare Matrx MX1Limited Warranty North America Outer CoverGeneral Guidelines SafetyInstallation Information Intended UseWeight Limitation and Model NumbersWARNING Operating InformationMono Mount Installation OverviewBefore Installation Included ItemsInstalling the Mounting Hardware Inch 23 cm Tall MX1 Back Cushions OnlyCarefully slide the rigidizer bracket onto the band clamp Band clamp in placeInstalling the Tracking Plate on the Back Shell Installing the Back Shell onto the Mounting Hardware Adjusting the Back HeightAdjusting the Back Angle Removing the Mono Mount Hardware Our customer service department Fixed Dual MountClamp Body Adjustment Repeat Steps 1-3 for the opposite sideInstalling the Band Clamps Installing the BackFixed Dual Mount Adjust the back to the desired height Loosen the compression bar hardware aAdjusting the Back Angle and Back Depth After InstallationLoosen the screws a on the side of both clamp bodies B Quick Release Dual Mount Loosening the Compression Bar Securing the Clamp Body to the Band Clamp Securing the Clamp Body Assembly to the Back Cane Inside View Adjusting the Back Height Removing the Back Cushion Adhesive Pads Installing/Adjusting the Lumbar Support Plug InsertsOptions Mounting holes B on the back shell CInstalling the Optional Privacy Flap WidthLaundering MaintenanceCleaning General Cleaning InspectionUsability Survey TRD0283 USA
Top Page Image Contents