Invacare IMX1 user manual Securing the Clamp Body Assembly to the Back Cane

Page 24

5 QUICK RELEASE DUAL MOUNT

5.8Securing the Clamp Body Assembly to the Back

Cane

1.Slide the clamp body assembly A to the desired height on the back cane B (Detail A).

2.Hold the clamp body assembly perpendicular to the back of the wheelchair (parallel to the rear wheel).

WARNING

DO NOT adjust the center screw in the clamp body. The center screw C is designed only to hold the compression bar in place during installation (Detail B). Adjusting this screw may prevent the compression bar from tightening properly onto the back cane.

3.Tighten the two screws D to push the compression bar E against the back cane and secure the clamp body in place.

When re-tightening the compression bar hardware, alternate back and forth between the screws until the compression bar is fully secured.

4.Repeat STEPS 1-3 for the opposite clamp body assembly.

The clamp bodies must be at the same height on each side of the back cane. Otherwise the back may not install correctly or at all.

DETAIL A	DETAIL B
	B
A	D	E
	C

Invacare® Matrx® MX1

24

Part No. 1171914

Image 24

Contents Invacare Matrx MX1 Model IMX1Invacare Matrx MX1 Contents Symbols GeneralOverview Important Information Invacare Matrx MX1Limited Warranty North America Outer CoverSafety Installation InformationGeneral Guidelines Intended UseWeight Limitation and Model NumbersWARNING Operating InformationInstallation Overview Before InstallationMono Mount Included ItemsInstalling the Mounting Hardware Inch 23 cm Tall MX1 Back Cushions OnlyCarefully slide the rigidizer bracket onto the band clamp Band clamp in placeInstalling the Tracking Plate on the Back Shell Installing the Back Shell onto the Mounting Hardware Adjusting the Back HeightAdjusting the Back Angle Removing the Mono Mount Hardware Our customer service department Fixed Dual MountClamp Body Adjustment Repeat Steps 1-3 for the opposite sideInstalling the Band Clamps Installing the BackFixed Dual Mount Adjust the back to the desired height Loosen the compression bar hardware aAdjusting the Back Angle and Back Depth After InstallationLoosen the screws a on the side of both clamp bodies B Quick Release Dual Mount Loosening the Compression Bar Securing the Clamp Body to the Band Clamp Securing the Clamp Body Assembly to the Back Cane Inside View Adjusting the Back Height Removing the Back Cushion Installing/Adjusting the Lumbar Support Plug Inserts OptionsAdhesive Pads Mounting holes B on the back shell CInstalling the Optional Privacy Flap WidthMaintenance Cleaning General CleaningLaundering InspectionUsability Survey TRD0283 USA