Invacare IMX1 user manual Inside View

Page 25

5.9Installing the Back

The instructions in this section apply to both sets of mounting hardware.

The right side is pictured in the figures in this procedure.

The mounting pin assembly A is secured to the slots B of the clamp body C.

A B

INSIDE VIEW

C

1.Loosen the four mounting screws securing the adjustable mounting bracket D to the back pan E.

2.Adjust the width of the adjustable mounting bracket so that it aligns with the mounting pin assembly on the clamp body.

3.Lift the lever F on the adjustable mounting bracket to unlock it.

4.Insert the upper and lower pins G into the notches H in the adjustable mounting bracket.

5 QUICK RELEASE DUAL MOUNT

E

 

G

A

3

 

H

 

 

2

 

 

 

 

4

D

F G

 

HC

5.Push down on the back pan to ensure the mounting pins are properly seated inside the notched recess of the adjustable mounting bracket.

6.Press the lever down to lock the back pan into place.

Part No. 1171914

25

Invacare® Matrx® MX1

Image 25
Contents Model IMX1 Invacare Matrx MX1Invacare Matrx MX1 Contents General SymbolsOverview Important Information Invacare Matrx MX1Outer Cover Limited Warranty North AmericaInstallation Information SafetyGeneral Guidelines Intended UseOperating Information Weight Limitation and Model NumbersWARNINGBefore Installation Installation OverviewMono Mount Included ItemsInch 23 cm Tall MX1 Back Cushions Only Installing the Mounting HardwareBand clamp in place Carefully slide the rigidizer bracket onto the band clampInstalling the Tracking Plate on the Back Shell Adjusting the Back Height Installing the Back Shell onto the Mounting HardwareAdjusting the Back Angle Removing the Mono Mount Hardware Fixed Dual Mount Our customer service departmentRepeat Steps 1-3 for the opposite side Clamp Body AdjustmentInstalling the Back Installing the Band ClampsFixed Dual Mount Loosen the compression bar hardware a Adjust the back to the desired heightAfter Installation Adjusting the Back Angle and Back DepthLoosen the screws a on the side of both clamp bodies B Quick Release Dual Mount Loosening the Compression Bar Securing the Clamp Body to the Band Clamp Securing the Clamp Body Assembly to the Back Cane Inside View Adjusting the Back Height Removing the Back Cushion Options Installing/Adjusting the Lumbar Support Plug InsertsAdhesive Pads Mounting holes B on the back shell CWidth Installing the Optional Privacy FlapCleaning General Cleaning MaintenanceLaundering InspectionUsability Survey USA TRD0283