Invacare IMX1 user manual Adjusting the Back Angle and Back Depth, Removing the Back Cushion

Page 27

5.11 Adjusting the Back Angle and Back Depth

1.Loosen the screws A in the mounting pin assembly of both clamp bodies B.

2.Adjust the position of the mounting pin assembly via the slots in the clamp bodies to achieve the desired back depth (Detail A) and back angle (Detail B).

Angle and depth adjustments must be made equally on both sides.

3.Tighten the screws on both clamp bodies to secure the back into position.

Detail A

Detail B

AB

A

5 QUICK RELEASE DUAL MOUNT

5.12 After Installation

1.Verify that all mounting hardware is fully tightened.

2.Ensure that the back is securely attached to the wheelchair.

5.13 Removing the Back Cushion

1. Unlock the levers on the adjustable mounting brackets.

2. Lift the back cushion up and forward to disengage it from the mounting pins.

1

2

Part No. 1171914

27

Invacare® Matrx® MX1

Image 27

Contents Model IMX1 Invacare Matrx MX1Invacare Matrx MX1 Contents Invacare Matrx MX1 SymbolsGeneral Overview Important InformationOuter Cover Limited Warranty North AmericaIntended Use SafetyInstallation Information General GuidelinesOperating Information Weight Limitation and Model NumbersWARNINGIncluded Items Installation OverviewBefore Installation Mono MountInch 23 cm Tall MX1 Back Cushions Only Installing the Mounting HardwareBand clamp in place Carefully slide the rigidizer bracket onto the band clampInstalling the Tracking Plate on the Back Shell Adjusting the Back Height Installing the Back Shell onto the Mounting HardwareAdjusting the Back Angle Removing the Mono Mount Hardware Fixed Dual Mount Our customer service departmentRepeat Steps 1-3 for the opposite side Clamp Body AdjustmentInstalling the Back Installing the Band ClampsFixed Dual Mount Loosen the compression bar hardware a Adjust the back to the desired heightAdjusting the Back Angle and Back Depth After InstallationLoosen the screws a on the side of both clamp bodies B Quick Release Dual Mount Loosening the Compression Bar Securing the Clamp Body to the Band Clamp Securing the Clamp Body Assembly to the Back Cane Inside View Adjusting the Back Height Removing the Back Cushion Mounting holes B on the back shell C Installing/Adjusting the Lumbar Support Plug InsertsOptions Adhesive PadsWidth Installing the Optional Privacy FlapInspection MaintenanceCleaning General Cleaning LaunderingUsability Survey USA TRD0283