Invacare IMX1 user manual Adjusting the Back Angle and Back Depth, After Installation

Page 20

4 FIXED DUAL MOUNT

4.9Adjusting the Back Angle and Back Depth

1.Loosen the screws A on the side of both clamp bodies B.

2.Adjust the angle adjustable brackets C in the clamp bodies to achieve the desired back angle and back depth.

Angle and depth adjustments must be made equally on both sides.

3.Tighten the screws on both clamp bodies to secure the back into position.

CB

A

4.10 After Installation

1.Verify that all mounting hardware is fully tightened.

2.Ensure that the back is securely attached to the wheelchair.

Invacare® Matrx® MX1

20

Part No. 1171914

Image 20
Contents Invacare Matrx MX1 Model IMX1Invacare Matrx MX1 Contents Symbols GeneralOverview Important Information Invacare Matrx MX1Limited Warranty North America Outer CoverSafety Installation InformationGeneral Guidelines Intended UseWeight Limitation and Model NumbersWARNING Operating InformationInstallation Overview Before InstallationMono Mount Included ItemsInstalling the Mounting Hardware Inch 23 cm Tall MX1 Back Cushions OnlyCarefully slide the rigidizer bracket onto the band clamp Band clamp in placeInstalling the Tracking Plate on the Back Shell Installing the Back Shell onto the Mounting Hardware Adjusting the Back HeightAdjusting the Back Angle Removing the Mono Mount Hardware Our customer service department Fixed Dual MountClamp Body Adjustment Repeat Steps 1-3 for the opposite sideInstalling the Band Clamps Installing the BackFixed Dual Mount Adjust the back to the desired height Loosen the compression bar hardware aLoosen the screws a on the side of both clamp bodies B Adjusting the Back Angle and Back DepthAfter Installation Quick Release Dual Mount Loosening the Compression Bar Securing the Clamp Body to the Band Clamp Securing the Clamp Body Assembly to the Back Cane Inside View Adjusting the Back Height Removing the Back Cushion Installing/Adjusting the Lumbar Support Plug Inserts OptionsAdhesive Pads Mounting holes B on the back shell CInstalling the Optional Privacy Flap WidthMaintenance Cleaning General CleaningLaundering InspectionUsability Survey TRD0283 USA