Invacare IMX1 Options, Installing/Adjusting the Lumbar Support Plug Inserts, Adhesive Pads, Shell

6 OPTIONS

6 Options

6.1 Installing/Adjusting the Lumbar Support					6.2	Plug Inserts
		The Lumbar Support is a pre-fabricated foam insert that			Optional plug inserts (Model DP-250) A may be used to fill unused
					mounting holes B on the back shell C.
		provides lower back support for additional comfort. The
		position of the lumbar insert can be adjusted inside the
		Invacare Matrx MX1 cover, or it may be removed if no
		lumbar support is desired					B	C
1. To access the lumbar support, open the hook and loop fastening strips
	on the outer cover A at the bottom rear of the back shell.					A
2. The foam lumbar support B is installed inside the Invacare Matrx
	MX1 cover between the foam back cushion C and the back shell D.
3.	The lumbar support can be adjusted to any desired height/position.
					6.3	Adhesive Pads
4.	Refasten the cover onto the back pan.
					Adhesive pads A are available to protect the back shell B from
			B	D
					scratches.
					1.	Peel the protective paper off of the back of the adhesive pad.
					2.	Install the adhesive pad between the back shell and the back cane
						C or other wheelchair component that may rub against the back
				C		shell.
A
							A
						A	C
								B

Invacare® Matrx® MX1 28 Part No. 1171914