Gateway AG-168V user manual Phone settings

Page 13

AG-168V SIP GATEWAY User Manual (V1.42)

recommended way with SIP protocol used.

dtmf: Set DTMF signal sending way by selecting control string, inband audio, signal keypad or rfc 2833 ,sip infofrom list box.

dtmf payload: set use RTP send DTMF’s RTPthe value range is 96-101

register ttl : IP GATEWAY will send a keep-alive registration message to SIP gatekeeper every “register ttl” seconds. The value range is 10-65535. Default is 60.

Super password : Set super password. Default is 12345678

debug: Set the debug level of the GATEWAY.

disable: Disable output the debug message by selecting this item.

output: Output the operation information to the window, such as register, input

by selecting this item.

output all: Output all debug information and data in test window by selecting this

item.

remote debug: Save the debug information in SDRAM of IP GATEWAY by

selecting this item.

no check: Disable checking firmware tags when upgrading. This is not

suggested, because it will increase the risk of upgrading the wrong firmware into

the GATEWAY.

phone settings:

13

Image 13

Contents Function Keys of AG-168V SIP Gateway Introduction Features Software HardwareOperating requirements Standard and ProtocolElectric requirements Gateway supports following standard and protocolSize InstallationPhone Keypad setup ConfigurationConfigured by WEB Is192.169.1.100 Network SettingPage Protocol Setting Page Register port phone number set local IDPhone settings Page inner line prefix default is Audio settings G729g7231g711ug711a and gsm Other settingsPhonenumber check phonenumber auto upgrade Button to confirm the modification Configured by PalmToolAG-168V Telnet Commands Explanation Telnet ConfigurationComman Command get Detail description of AG-168V Telnet commands Command ?Get SetInnerline 1enable Localprefix Detailed description Set iptype Command set Syntax description set keywords valueSet ppppin Set pppidSet ip Set subnetmaskSet service type Set serviceSet router Set dnsSet serviceid Set serviceaddrSet nattraversal Set nataddrSet natttl Set signalportSet GATEWAYnumber Set accountSet rtptos Set registerttlSet rtpport Set jittersizeSet dialplan Set dtmf payloadSet dialnumber Set dddcodeSet dddprefix Set iddprefixSet innerline Set localpreifxSet digitmap Set fwdpoweroffSet fwdnumber Set fwdalwaysSet vad Set 6.3kSet agc Set aecSet superpassword Set passwordSet codec2 Set codec3Command store Set upgradeaddrRelevant Usage store Command load Relevant Usage load Command exitFtp command Syntax description ftp value Command ping Syntax description ping IP addressRelevant usage ftp Call with ip address Usage of AG-168V FXSCall when Pstn first Dual mode enabled Telnet command to updating Upgrade AG-168V IP GatewayUsing Http Prepare Updated program through FTPHardwareTagServiceTypeProtocolXXX.bin Ocheck.The configuration All rights reserved