Gateway AG-168V user manual Set natttl, Set GATEWAYnumber, Set account, Set pin, Set registerport

Page 27

AG-168V SIP GATEWAY User Manual (V1.42)

www.ipchicken.com;www.showmyip.com;www.whatismyip.com; www.myipaddress.com; www.whatismyipaddress.com; ip.sbbs.net; www.whatismyipaddress.net;checkip.dyndns.org

set natttl XX

Set NAT TTL XX is an integer between 10 and 65535 sec. default value is 20

sec.

set GATEWAYnumber XXXXXXXX

Set a GATEWAY number of AG-168V IP GATEWAY . Value xxxxx must be

an Arabic numeral and no longer than 16 characters.

set account XXXXXX

While calling card is set, set account of chosen card; while local type is set

use authentication type, set user ID; while set localtype is set as 1, set SIP

ID.

set pin XXXXXXXXXX

While calling card is set, set password of chosen card; while local type is set

authentication type, set password.

set registerport XXXX

Set register port. XXXX is range from 1024 through 6553.

set signalport XXXX

This port is Q.931 port using TCP protocol. XXXX is range from 1024 through

65535.

set controlport XXXX

This port is H.245 port using TCP protocol. XXXX is range from 1024 through 65535.

27

Image 27

Contents Function Keys of AG-168V SIP Gateway Introduction Features Software HardwareGateway supports following standard and protocol Standard and ProtocolOperating requirements Electric requirementsSize InstallationPhone Keypad setup ConfigurationConfigured by WEB Is192.169.1.100 Network SettingPage Protocol Setting Page Register port phone number set local IDPhone settings Page inner line prefix default is Audio settings G729g7231g711ug711a and gsm Other settingsPhonenumber check phonenumber auto upgrade Button to confirm the modification Configured by PalmToolTelnet Configuration AG-168V Telnet Commands ExplanationComman Set Detail description of AG-168V Telnet commands Command ?Command get GetInnerline 1enable Localprefix Detailed description Set iptype Command set Syntax description set keywords valueSet subnetmask Set pppidSet ppppin Set ipSet dns Set serviceSet service type Set routerSet nataddr Set serviceaddrSet serviceid Set nattraversalSet account Set signalportSet natttl Set GATEWAYnumberSet jittersize Set registerttlSet rtptos Set rtpportSet dddcode Set dtmf payloadSet dialplan Set dialnumberSet localpreifx Set iddprefixSet dddprefix Set innerlineSet fwdalways Set fwdpoweroffSet digitmap Set fwdnumberSet aec Set 6.3kSet vad Set agcSet codec3 Set passwordSet superpassword Set codec2Relevant Usage load Command exit Set upgradeaddrCommand store Relevant Usage store Command loadCommand ping Syntax description ping IP address Ftp command Syntax description ftp valueRelevant usage ftp Call with ip address Usage of AG-168V FXSCall when Pstn first Dual mode enabled Prepare Updated program through FTP Upgrade AG-168V IP GatewayTelnet command to updating Using HttpHardwareTagServiceTypeProtocolXXX.bin Ocheck.The configuration All rights reserved